I have 2 T1 line from 2 service provider connecting back to the same router.Do I need to upgrade IOS software in order to do load balancing and redundancy between these 2 lines.Any good website for references on the configuration.
Hello. I am trying to configure a "router on a stick." My hardware is a 2620 router attached to a 2924 switch. When attempting to put an ip address on the fa 0/0.1 subinterface, I receive the following message:Configuring IP routing on a LAN subinter...
I have read and followed the steps for RME configuration management to use SSH, but is there a way to get Campus manager, Ciscoview etc to use SSH? Can the underlying files be modified to change the command pushed down to the client? I need to set up...
I would like to how does inter vlan routing is handled by this layer 3 switch. I understand without configuring any routing protocols like RIP and OSPF, a layer 3 switching is possible by assigning individual vlan interfaces with IP addresses or IPX ...
Hello.My client have a flat network ( LAN , about 700 users , 100 printers,100 servers , protocols are IP and Decnet ) .That will be separated to 12 vlans. The issue is a decnet traffic between vlans . How can i configure it ? Bridging ? IRB ? What ...
Hi,Any body tested the redundant SUPIV on Catalyst 4507R, I looking for time to fail over from the active to standby SUPIV.Ist it the same time like 6509?Thanks
We're currently running 200 remote offices (using 1751's) terminating on two Cisco 3640's via frame relay pvcs. We use the 10.128.0.0/24 network space at both ends of the frame relay links and are using a single OSPF area for routing.For about 20...
Hi,I have an AS5300 with 4xE1/PRI ports. I have 2 E1 line from telcom which comes from different switches and i think have clocking problem. Can I configure NAS so that each E1 port get its clock from corresponding line? when i set "clock source line...
Hi All,Current setup: internal LAN on 6509, DMZ on 2 x 2924 switches, outside on 1 x 2950-12 connected to the internet via 1720 router - the 3 LANs are connected together by a PIX520. We have two webservers on the DMZ that are currently load balanc...
Belowing output was generated on the routeserver, both 61.140.0.0 and218.14.0.0 belong to ChinaNET, but the route server choose diffnext hop for them, the complete "show ip bgp regexp _4813$" indicatedthat there are about 4 next_hop to AS4813 from t...
When would you use a Reflexive ACL? would you only use this for say a database or SQL session that would return on a different port? normal traffic should be covered correctly in just an extended. Is ther emuch difference between reflexive and conte...
Hi,I found one of our customers with its net I contend 1000 hosts in one vlan with the configuration of switch 6509 for switches of edge 3550 with duplex half and 100 Mbps. Which would be the best configuration between switches Core and switches of t...
Hello, Can someone please help and explain why this configuration is not working correctly. I am trying to get my 3 iBGP subnets redistributed into RIP in order to send them via RIP to the PIX connected via eth0. iBGP works fine and does what it nee...
We have currently deployed multiple 4006s in our campus network. Now we want to go in for new ones to connect new buildings to our campus wide LAN. I would like to know whether we should go for 4006 with sup-II/4232L3(existing config) or with 4506 wi...
