Hi Friends, I need guidance regarding VLANs on L2 Switches(2950 Model).If I create VLANs on these How do they talk to each other. I have a 2600 Model Router. Suppose I create 3 VLANs on a Switch how are these 3 going to talk ...
Hello,10 minutes after the installation of a new 2950-24 with IOS12.1(11)EA,we got this error message :SCHAN ERROR INTR: unit=0 SRC=6 DST=5 OPCODE=20 ERRCODE=5We loose all network connections,all traffics. After reboot + 10 Minute...
Hi,I have a router 2620 and i want to give him some priority on some flow. So i decide to use the priority-list command, but that don't seem to be good. I try to use a netmeeting between 2 compueter. For see if it's work i launch a some ftp for tes...
Hi All,My company thinking use 3725 router to replace its old 4000 router. I saw there is a 36-port Etherswitch network module can be used in 3725. Does anybody know if all the ports of the module can be used for routing (and can assign an ip address...
I have just seen the following config on a customers 3550 and would like to know what the "switchport access vlan 110" command does as the links are supposed to be dot1q trunks!interface GigabitEthernet0/3 switchport access vlan 110 switchport trunk ...
Can anybody tell me how you configure an async line to display a host menu once connected ? e.g. 1. Host A 2. Host B 3. Host C.We have a support company that uses the ATDT command via a terminal emulator, but once they connect all they get is a load ...
Current SetupA remote office D is connected to Headoffice L. I have a Nortel Router at D, the serial interface (ppp) links to Head office. LAN1 is token ring and I have 5 departments (total 30 users) connected to tokenring. LAN2 is 100meg ethernet in...
We have a typical type of scenario where customer has 30 differrent remote branches to be terminated to the central router.Omantel ( Service provider ) has suggested a channelised E1 leased line to the customer which will accomodate all the 30 branc...
Hi all,I have following network diagram,Router1(2651XM)|switch1(2950) -- VLAN1 |VLAN2 -- router2 (pc) -- LAN3Router1 and switch1 are configured as router on a stick config (with VLAN1 & VLAN2). Another PC(acts like router2 to LAN3) is being added.A ...
What actually happens when a packet is dropped on the internetwork ? What does the term "drop" exactly mean ?Is the packet extinguished/destroyed in any way ?
I have a dial-up connection thru telephone at my home..Whenever I connect to the internet thru dial-up over telephone line, I get the following output for "ipconfig" and "ping" on the DOS Command prompt.The command fired and output is as follows:Wind...
hi allone of our isdn customer has done some R&D with his router by changing the authentication on both console and vtys.eariler ther was a passwd set but he changed the login to local without setting any username or passwd.is ther any way out to bre...
Hello all, Could anyone please suggest me, in what way, neighbour command will give advantage except for unicast packet in IGRP? The below configuration is in "192.168.3.1" router.Eg: router igrp 100 network 192.168.3.0 ...
