Other Network Architecture Subjects

We have a client server setup with multiple vlans trunked across the uplinks .We manually pruned all unused vlans off the trunk at the distibution layer and if you look at the distribution layer it will say like only 2 vlans allowed on trunk . My ...

ive entered set enablepass XXXXXXX.and responsed with :useage:set enablepassive then realized what ive done.now i cant use the old ant the new password neither.do i have to apply paasword recovery?any idea?

Hi All,Can policy routing modify the source ip address? If I can, how can I config? thank you!!Best RegardsTeru Lei

--begin ciscomoderator note-- The following post has been edited to remove potentially confidential information. Please refrain from posting confidential information on the site to reduce security risks to your network. -- end ciscomoderator note -- ...

HiI'd liked to know if there are any limitations with having multiple standby groups on a per vlan basis under MLS i.e.On CAT5505 #1 interface Vlan11 ip address 11.1.1.1 255.255.255.0 no ip redirects standby 11 ip 11.1.1.3 standby 11 priority 120...

I have configured 2 vlans on a 2924 switch, both say they are active and I know for sure vlan 2 is working (vlan 1is set to management ). But when I look at "sh int vlan 2 or 3" the interfaces state they are admin down line protocol down. Why is tha...

I have a Red Hat 8.0 Linux NTP server that is synchronizing successfully with an Internet NTP server. I want all my Cisco devices to receive NTP updates from the Linux server. When the Red Hat server sends a NTP packet, it does not send a valid ref...

Maybe someone could shed a little light on the matter, because I am a little confused. On my Cat6506, MLS is disabled globally(No MLS statements whatsoever). When I exit to the switch and do a "sh mls entry", It is showing cached entries("305 total...

00:00:14: %EPAMCM-0-INTERNAL_PANIC: ls_epamcm_process: Error while verifying the download-Traceback= 60331474 60098D84 60098D70 GigabitEthernet4 reset 0 image id 0 source 100:00:16: WARNING: This will force the link-up ...

When we do the MSFC Configuration Synchronization on 2 MSFC within the same switch, how do you specify which MSFC is the source and the other is the target need to be synchronized?

LMS 2.1 with latest IDUs for all components. NO DNS running on network at all. ANI discovers devices and they are shown in Topolgy views for a while. If I close Topology services down and launch it several hours later, all topology views are blank, n...

I am un able to send or receive packets across my WAN. Surprisingly the statics of the show interface command of routers on both ends of the WAN shows something like this. Serial1/3 is up, line protocol is up Hardware is CD2430 in sync mode Descri...

I'm looking for a MIB to get the dialer string configured on dialer interfaces (Cisco 3640 router).When checking the IF-MIB to check the OperState of a dialer interface, it's always "dormant" (5). How can I check, if a specific dialer interface is up...