Other Network Architecture Subjects

hii have 2 routers A and B connected via a kilostreami can ping from router A to router Bi can ping router A to switch A on same network segmenti can ping router B to switch B on same network segmentbut i cant ping from network via switch A / router ...

Can I add a point-point sub-interface with a frame-relay dlci command to a serial interface that already uses frame-relay map commands at the primary interface level; i.e. would both pimary and sub interfaces work on the same serial port?Thanks and b...

Background: I have 2 routers; 3640 and 3660 connected to the same LAN, each of these routers provides access to remote sites using 1750's via primary Kilostream links with ISDN BRI links as backup. Each 1750 has serial interface providing Kilostream ...

it seems that there has some problem with the DDN link ,i use ping to test another end of the link , there has a strange output:Reply from 61.*.0.2: bytes=32 time<10ms TTL=224Request timed out.Request timed out.Request timed out.Request timed out....

I'm trying to implement some sort of anti spoofing measure on my router (Cisco 806 DSL router) and was reading about uRFP. From what i understand you can use this in place of applying ingress and egress ACLs on the interfaces connecting to external n...

Hello Gents,If I plan to transfer 300MB of data across following link: 1) a 64K terrestrial leased line 2) a 38K terrestrial leased lineIsn't there a formula for doing this?? I believe i had come across such a one in the past. Can anyone of you shar...

How to use 2503/2513 for sharing broadband Internet access that is one gateway with NAT for all the local client PCs to share one local IP address for pppoe connection. I check the ethernet port with one command "pppoe enable" only, nothing I know to...

I just installed LMS 1.2 with cd one 5th edition, RME 3.4 and campus 3.2. for Solaris. After the installation finished, I managed to do some settings for the ani service, but while doing this my browser (internet explorer 6.0) hung up and since then,...

If I try to connect a 2950SX-24 with a MT-RJ connector, via a MT-RJ/SC cable, to 3524XL with a 1000base-X GBIC. It failed to make a connection. I don't see the led's going to amber or green. I tried many cables and a second 2950SX but with the same ...

I have a 128K kilostream which is suffering from conjestion caused by bursty traffic. The link currently uses compression and I'm considering using WFQing. I seem to recall reading something about issues when using queuing in conjunction with link co...

Hi,I'm trying to add the image of a Catalyst 2900 to the software library, but I get the following message : "Image import operation not supported". I can put a new image in the device but I can't retreive it. Is this normal ?Thanks !Marc F.CS Studen...