subnet --- ------ router----- ----subnet ----Cisco 675----WAN192.168.1.0 .3 ---- .3 192.168.2.0 ---- .1CBOS will not allow me to add the following route in this configuration:set route add ip 192.168.1.0 gw 192.168.2.3I don't get why it won't al...
Have other people had success with the 1434 tcp/udp acl lists? I don't seem to be getting a comfortable block either with inbound or outbound and have tried applying to both main interface and subinterfaces. Though I am picking up the offending ip's ...
I received this request. How do I increase to 380ma?Cisco's web site said they draw 350ma of current, but can go up to a maximum of 380ma in some cases. Would you set these to provide the maximum recommended power of 380ma (16 watts)?Thanks in advan...
I am trying to implement DTS on a 7500. When I turn on the traffic shaping, I begin to have a large number of late-dropped out pkts on PVCs that I am not even doing traffic shaping on:kylex7500b#sh fram pvc 636PVC Statistics for interface Serial5/1/...
Hello, We would ike to manage multiple VPN concentrators using VMS 2.1. We have RME working and VPN Monitor and that is it.Can we do something in CSPM or Management Center for the concentrators or are these products only for routers, PIX or IDS?FYI -...
I have a requirement of configuring multiple ppp multilink bundles between two routers using virtual-templates. I cannot use Interface multilink because its not supported by the IOS. How can I configure it using multilink virtual templates and interf...
I have a cisco 800 router and I getting the message "44: 01:04:32: %IP-4-ZERO_ADDR: Zero MAC address for 10.9.135.1 in ARP cache". Does anyone know what this means? When I check the ARP table, the ethernet interface of the router displays a MAC of 00...
Can a CiscoWorks server export the database of configs it collects from polled devices to a tftp server? If so can it do it as a regular scheduled job?
would be interested to hear general comments/opinions about standardizing on one manufacturer for core and access lan switches... am guessing that there are not a lot of interoperability/compatibility issues between major manufacturers? for example, ...
I have IOS c2600-js-mz.122-6c on a 2621 chasis and I am trying to make it dial out on the BRI interface. I have set 2 BRIs together to back the leased line.The dial does NOT work and what is puzzling me is the foll line:Jan 27 16:53:12 UTC: ISDN: get...
I have been told Cisco Works 2000 does not accept SNMP Community Strings with special characters such as *, &, @, !. I can't find documents to support or disclaim this.Is this true with anyone elses Cisco Works 2000 server when doing discoveries? ...
We have a customer that connects to us over frame with two pvc's to two of our sites. One pvc to each site. The customers remote network ip addresses overlapped our local ip addresses so we had to setup dynamic and static NAT on their routers. The in...
If I've set up the mgnt vlan on my cisco switches to be other than vlan 1 do I need to .....a.) Shut down vlan 1 ???b.) use the key work "management" when declaring the mgnt. IP address on 4006's or 3550's thanks,~zo
I think I have the 776 Installed at this site. The main question I have is this.. I have the router hard set to goto a particilar IP on the other side of the router.. Now I have a need to install a second router on site, this router will do a VPN tu...
