Other Network Architecture Subjects

Hi anyone please help when I set the following AAA to my router, I can't telnet to my router anymore;router(config)#username Rclinic1 password0 ciscorouter(config)#aaa new-modelrouter(config)#aaa authentication login default localrouter(config)#aaa a...

>i have two 6509. These two 6509 have to connect to remote sites via leased>line.>>So i have two FLEX module at each 6509, with a WAN module located at each FLEX module.>>However, after booting up, the FLEX LED module at one 6509 remains red>(while ...

I have a 4006 with a Sup III. I have 3 VLANs configured on this switch and have a Cisco 4700 connected to one of the Fast Ethernet ports of the switch, this port is a member of one of the 3 VANs. I have enabled eigrp 2 on the 4006 and was just expe...

is access gateway module supported in 4006-S3 & 4006-S2. i am not able to configure this module. if it is not supported when is it likely to happen. i need to advice my customer accordingly.if no support is possible in next few months what is the alt...

Dear All,I have instaled a 2950 switch and the customer whant to enable port security on 3 ports with a mac address.The problem is when i write it comes with the error: (config-if)#switchport port-securityCommand rejected: Not eligible for secure por...

Hi, I am working in an ISP. We are having asymmetric TX and RX carrier from one of our providers and running BGP with them. Our setup for this particular carrier is like this.Tx -- S4/1/7 with IP address 192.168.4.5Rx -- S4/1/5 using IP address of...

Could some send me the pin out details for CAB-E1-RJ45 cable for CE1 port adapter for 3662 router?

Hi,Understand that catalyst 4006 switch has 64 Gbps backplane speed.Also understand from the maximum port density table of catalyst 4006 as10/100 - 240 ports, 100 Base FX - 240 ports.Also understand that this switch supports 10/100/1000 - 240 ports....

I was thinking of a means of preventing someone in a small remote office from plugging in an 802.11 network and opening up the internal network to perusal from whoever. The offices are dynamic with one person or another plugging in their laptop to ...

Hi AllWhen I do a "sh ip route" on our 3550 router, it only shows one route to each network that it knows of.When I do a "sh ip route" on our RSM router, it shows four routes to each network that it knows of - one of which is always an active VLAN on...

Hi anyone please guide from the websites, is there any sample configuration guides for FEW remote branch routers connected back to HQ router with a leased line and ISDN backup link.Sample need to show the dialer maps or dialer profiles at HQ and bra...

I'd be glad if anyone could tell me how to get more info in the logs on the 3550. I'd like to see, for example, an entry in the log when someone telnets to the switch. Thanks!#sho logging Syslog logging: enabled (0 messages dropped, 0 flushes, 0 over...

Anyone know how to block access to a port on a Cisco Catalyst 3550 managed switch so only a range of IP Addresses can access the port and all other connections get discarded?Thanks and regardsJoe

What is the point of this command? If I wanted to keep certain ports from talking to one another at layer 2, I would put them in different vlans. Why put them in the same vlan and then segregate them with this command?

Boy it is one of those weeks.... finally got everything installed but now I keep getting messages for the ACL, DFM, Content Flow, Campus Manager, RME, that the licensing has expired....Anyone ever hit this??? and what's the fix.... since I have never...