Other Network Architecture Subjects

Hi all,I see in the Medianet config guide this lineRouter(config-cmap)# match application testapplication. from the application name, it looks like Application names are configurable/ customizable. Is this correct? How? i don't see in the config guid...

Hi, I am wondering about best practices when trying to mark and classify webex video traffic from the users PC client.  I have looked around and nbar is possibly one option or i could match on the destination and ports of the traffic.But i'm wonderin...

Hi all, comparing NBAR to Medianet Metadata, is it fair to say that Medianet only distiguishes between RTP traffic types while NBAR covers a wider range of applications including HTTP-based applications?Please also confirm that Medianet Metadata mand...

Experts,One of my data centre switches is logging below errorsMay 22 15:49:15.121: %CONST_DIAG-SP-4-ERROR_COUNTER_WARNING: Module 1 Error counter exceeds threshold, system operation continue.May 22 15:49:15.121: %CONST_DIAG-SP-4-ERROR_COUNTER_DATA: I...

We have 3 Cisco 4507's, all have 2 supervisor modules and we have GBIC's in all of them. My question is can we use the supervisor uplinks to connect these switched together. We will not be using fiber, it will be CAT 6 connections. Is the only way to...

We have a wireless controller 5500 at a hub site.  The remote sites are running the aironet 1142 wap in controller mode.  We configure dhcp option 43 at the remote isr's and the 1142 remote site waps's join the controller's as they should.  The 1142'...

Hi all,  Are the application types supported by flow metadata statically defined within the switch OS and is therefore OS release dependent? Or are they dynamically learned by the network devices and customizable?Is there also a comparison table betw...

HelloI want to configure QoS to prioritize bandwidth for one ip address. Sometimes link bandwidth overflows. When overflow occurred for one ip address we must guarantee 5 mbitsPlease see config acl 100 permit ip any host x.x.x.x class-map match-any l...

Hi ExpertsThanks cisco Netpro for this great section which indeed helps Cisco pre-sales engineer , Network Engineer and senior Network to build a resilient network , also i hope cisco NCEs and Cisco Advanced Services team to contributes like before i...

Hi everibody.Can I put a interface card : NM-1FE-TX—One-port Fast Ethernet (10/100BaseTX interface)   on a 2610XM in order to obtain the second Fast Ethernet port??Thanks Massimo

          Hello guys...I need help to setup a best cisco design for my new locations:I have 172 buildings that will connect with fiber (single mode)Each building of this will use L2 switch with 24 port and also POE with 370 Watt power.In head office ...

i am tring to setup a 5508. 15 of the 16 aps will be at a remote sitethe 5508 will be at HQ (would like this)at the remote site i have 6 2960-s and a asa5510this site is a sub site of another site the vlan 1 will be part of the main site which is con...

Hello,I'm working on options for a small DC switch design.  This DC has 5virtual hosts with 10-20 guest vm's each.  Each server has two quadport gig nics with 6 of the 8 gig ports connected (3 for iSCSI and 3for data or management.  It also has two 3...