Other Network Architecture Subjects

I have serval 26oo seris routers that will drop the IPX routes and servers at wiil. They are running 11.3, has anyone seen this problem and is there a fix outside of upgrading the IOS

I have a 2610 at a central location that has 2 56k wic using to connect to branch offices using 1602's. So far only one of the 1602's can connect to the server at the central location. The second 1602 can see workstations behind the other 1602 but ...

I have 2511 router with 4mg mem process, and 8mg flash, I need an IOS that fits the hardware capacity and will allow me to run Tacac.Any suggestion

Hi Folks,Really i need your help to undestand the output of a debug dlsw command.My customer has a sporadic problem, suddenly the circuit goes down, but the dlsw peer keeps stable. There are not CRC errors, input/output errors at the serial interface...

When using RME for configuration management an important part is missing for IOS switches like 3500 and 2900. The part I'm missing is the VLAN configuration stored in the VLAN.DAT file in IOS. It seems that RME doesn't collect this part. Is this corr...

Hi all,is it possible to configure snapshot routing with a BRI interface when ppp multilink is enabled?

Is this a valid command to add on a an ABR?area 0 range x.x.x.x

Dear sirs,We would like to know if it`s possible to configure full duplex on an interface ethernet to 10Mbps on Cisco Router.If it`s possible, could you help me with the IOS which suppot it.Thanks in advance.Best regards.Carlos Zelayandia

We have 10 Cisco 2621 routers all running Version 12.0(7)XK1, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1) with 28672K/4096K bytes of memory. After making some config changes I use the Clear ip route * and the clear arp-cache commands. Several of the ...

I have a 2912F that is currently configured on one network as VLAN1 172.16.2.192/23. I need to make f0/10, f0/11, f0/12 and f1/4 be on the 172.16.200.0/23 network. What is the best way to do this?Thanks

I am using Cisco works 2000 and I am able to connect to Management Connection, and query a TAC case. However, when I try to Check Contract Status under Essentials, Contract Connection or, more importantly, Add Images to the Software Management Libra...

I am looking for a sample config using multilink frame (FRF.16) on a 2600 w/ 2 Frame T1's.

How can utilize (load balance) my interent access through two different internet providors ? is BGP the only solutions ?

The manuals say (from Cisco, by the way) that out of a T-1 the most you'll get is 70-80% of the total bandwidth (this would be typical serial interfaces - ATM could be somewhat faster, depending on a lot of variables.....). With the IMAs, they have ...

Configuring a core dump on GSR LC