Hai all, I am need of Cisco CGS DB-25 to V.35 interface serial cable specifications. If anybody knows, please give me the specifications.I have searched "Cisco" web site, but couldn't find it out.Thanks in advance...Regards...--Ashok.
Is it possible to configure a 2621 router to forward packets from a LAN connected to fastethernet0/0 to a proxy server connected to fastethernet0/1 using port 1111 as the proxy port? Can you set up the router to act as a proxy client like that?
Is there a way to set 2 different values of BW on a FRSM port on a MGX 8850, so that the Egress value is less than the ingress value, i tried both cnfchanpool and xcnfchan with no luck as they alyways assume i'm oversubscribing the egress value not t...
We have an AS5300 (12.2 IOS) with mica modems and a PRI. We are using DialOut/EZ for outbound modem connections. Everything is working fine for local numbers, but we are having a problem with long distance. Our company has it setup through our telco ...
I am attempting to enable a Cisco 1710 to do Backup DDR to a Cisco AS5200 that is also being used to provide 56K analog connectivity to remote users. The problem is that upon establishing a connection, the AS5200 assigns the line an ip address from...
In a LLQ configuration, can you mix "bandwidth percent [%] " statement and "bandwidth [kbps]" statement within the same policy-map ?? CCO url says you cannot. But if you read the URL that I pasted here, it says, you can mix these 2 statements betwee...
One of the most difficult tasks I've had is to document the technical aspects of our enterprise network, so that there's enough information to allow technicians and engineers to troubleshoot and make design changes. Has anyone found a relatively simp...
I have a hub-spoke Wan design. The hub is a T1. The spokes are all smaller than a T1. I was thinking about implementing traffic shaping at the hub because I am seeing some congestion at two of the remote sites and will be installing some application ...
I have a couple of AS5200 routers that keep losing their running config. They still have their startup config, so I can just reboot. Has anybody had this happen, and is there anything I can do? Thanks in advance.Jpoulos
Auctully I could not install my ISDN modem on my Cisco 2621 Router for incomming ISDN connection on serial interface.Could it be possible to install ISDN Modem on serial interface of router for incomming connection.Auctully I could not find any relat...
Hi,I have a 2Mbps point to point leased line between 2 places, I want to slice the bandwidth Half, like 1Mb for all the FTP traffic. remaining 1 Mb for Telnet traffic.Can I do this using frame-relay? If so, Please guide me on this. I am going to conn...
Is this the proper way to configure NAT ona Serial Interface if I have only one routable IP address?Current configuration : 1021 bytes!version 12.2service timestamps debug uptimeservice timestamps log uptimeservice password-encryption!hostname Liver!...
I have a Cisco Catalyst on a public IP, and an SNMP management PC on a public IP as well. I've found when testing the managerment software, SolarWinds and WhatsUp, that when I run the management software from a private IP address, I can reach the ca...
We are using the auxiliary interface of a 2610 and 1720 to link each other.Then from the 1720 we are using a serial interface WIC 1T to connect to an Automatic tleller Machine through a modem connection. The modem connection is asynchronous.In normal...
basically we have two networks, for the admin that could access IBM AS400 and Internet ; and for the students that can access the internet only. We are planning to implement VLAN on our network. But we only have 1924 catalyst switch standard e...
