How to use two router backup for each other use the different WAN ?
How to use two router backup for each other use the different WAN ?
I'm looking for information on a MICA Modem Port Adapter to be used in a 7204 to facilitate dial-up remote access. I've queried CCO with the following strings "7200" and "MICA" and "modem" and "port adapter". I understand the 3600 series chasis sup...
I have configured cisco 2621 router for one incomming bri session, such that user when dials get the ip addrss form Winnt DHCP server, But could not communicate form the network i-e nor ping the same network or communicate.Even entring the static rou...
i have a catylast 4003 that has a "piggybacked" catalyst 3548 on one port. this has been working fine until yesterday. i got a message that this 3548 was down. both devices showed connectivity, but i could not get the 3548 to work. logged onto co...
Can the Catalyst 1900C software be upgraded from v5.35 to v9.00.04
two routers connected over a leased line to connect two WAN locations,I wish to bridge the two WAN locations to form one network 10.1.0.0/16 ,the serial interfaces and lines are up with no problem still I fail to have connectivity between the locatio...
If I'm using 256k fractional T1, what is the proper timeslot settings?service-module t1 timeslots 1-4 speed 64, right?
Hello,We need to implement 4-OC12/ATM in a 12008GSR,would i need to implement a full CSC x1 and 3 SFC`s ?Is there any document which suggets the requirements for different combinations ?I did search the CCO, but could not find much information.Please...
What is the limit for atm subinterfaces?Ex. ATM2/0.1 through ATM2/0.99Then it would go to ATM2/1.0Then on through ATM2/9.99Is that correct?Thanks in advance.
Hi all,I have set up a Cisco 1603 router to perform DDR to our remote access server, which is running Windows NT4 + RRAS and with PRI interface card (E1, 30 lines). I used the Cisco Configmaker to do the job and that Cisco 1603 does sucessfully conne...
A colleaque is currently investigating the possibility of starting an isp service in one of the west african country and would like an assistance in naming all of the Cisco equipments that will be needed to implement this project.I would appreciate a...
HiI wish to know what is best wat to connect to 2 isp'sTIAMichael Polevoy
Is a 4500M series router packed with a NP-1FE and NP-1HSSI interfaces and 32 megs of ram good enough to route a DS-3 to my ISP?? Will I have performance problems?Ian
I am configuring an AS5200 Router to accept 2 T1 lines. One going to Controller T1 0 and the other going to Controller T1 1. Each T1 has its own telephone number. I have 24 56k modems. I want Controller 0 to have access to modems 1-3 and Controll...
Regarding Cisco products, where can I start to evaluate a fast ethernet redundant fiber ring? Someone had mentioned incorporating a head-end switch in the ring performing the spanning tree protocol.Brett
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Subject | Author | Posted |
---|---|---|
08-07-2024 06:15 AM | ||
07-17-2024 11:08 AM | ||
07-17-2024 06:07 AM | ||
05-29-2024 04:52 AM | ||
02-14-2024 04:00 AM |