Other Network Architecture Subjects

Hi All,I want to view the events log of router 3640. As there is not enough memory in the router to store history of all the events, how can I store events logging to remote server. What sort of software do I need for server (Windows NT). Is it Cisco...

Hi All,I have two 6509's, with two Supervisors and Highavailability configured across the SUp's on a box and HSRP across the four MSFC modules. I have configured HSRP for load balancing, such that all ODD VLAN's have the primary router on one box and...

Hi, Do I need to configure bridge group (irb)in 4908G if I have to pass Vlan information from one switch to another switch that are connected to 4908G?regards,Silju

Dear all, Does anybody have any idea if BPX 8850 can

Here's something that I wish I didn't have to ask! I have a remote site with two parallel WAN links, both *bridged* instead of routed, one faster than the other. I inherited this, it is one of the oldest WAN links in the network...Please forget the f...

I hope this question is not benieth this forum.. I'm stuck in a bad situation.. My company's router guy is on vacation in the tropics for like 2 months (don't know how he swung that!!).. So my boss gets this great idea that a new WAN link needs to go...

I have a customer with an ISDN 56k point to point conn. that is not working with (2) Motorola uds csu/dsu. What equipment could i use to replace the csu/dsu?

On the cisco rotuer ,I see messages like this "recovery on timer expiry",meanwhile link lasts for ten seconds then get down.How can I do with it?When this non-cisco router dial into cisco rotuer of different places by dialing a different isdn line...

Recently I upgraded a 3640 from 12.0.5 to 12.1.7, and notice that IOS doesn't regconize the NM-2FE2W card any more, it says "no iomem table entry for PA(0xD8) in slot0". run "show diag":fwa>sh diagSlot 0: Unknown (type 216) Port adapter ...

I have a catalyst 2950. I Created 3 VLAN 1,2,3 and F0/24 port as a trunk port. I Connected this port to a server but only user on VLAN 1 can access to server.Pls help me to solve this problem .Thanks in advanced

Is it compulsory to have area 0 , even when the design has only one area to be created.Can we define different areas on primary and secondary address of the same interface.Tanx

i changed a NM4E to NM2FE2W recently but the router, a 3620 with ios version 12.1 did not recognize or sh it in any sh command could you pls assist me in telling what could be wrong and a solution to the problem?

What is the best configuration for a larger network (more then 200 host).I small networks a switch is configured for 100 MBit and full duplex on all ports. Can this cause performance problems in a larger network if all ports are on 100 MBit full dupl...

Does Cisco make a DOCSIS compliant cable to ethernet router?Specifically I support several SOHO users who are on the roadrunner network and I would like to replace the provided CPE.

I have bad experience today, one of Cat 5000 hang or down and my colleagues reset the switch so some logs were missing.Can someone tell me possibility Catalyst 5000 down/hang (software or hardware possibilities)? (beside electricity problem).Thank yo...