Hi, i would like to impliment VTP Pruning on my VTP Management Domain however I would like to confirm that unless i have a port configured as access for a specified VLAN, that VLAN will be pruned. Here is why i ask, i have devices that do their own 8...
Recently I found that 802.1q trunking on 2610 platform will fail because of ARP reply filteredConfiguration below!interface Ethernet0/0 description Connection to CORSW1 F0/6 no ip address full-duplex!interface Ethernet0/0.1 description Vlan 46 connec...
Hi, i get an error message"copy tftp: flash:%Destination file system is read-only". while upgrading the IOS on my Cisco 2503 router, also when i verified the show flash it says READ ONLY, how to make it as READ/WRITE?
Hi, I have a single 3550 that I want to setup with only 15 hosts. when I put a basic config on the switch the ports do not become active "up and up". I'm sure i'm missing items but attached is the 3550 config. I have one laptop connected to a switch ...
I've done the Cisco search and came up empty. I used to know this. Isn't there a hidden remove command? Version is CatOs 8.4.1. Hopefully one of you can save the day. TIA!
I am tring to find the commands to upload a file from a server to flash on a router. Where on the server does the file have to be? I have tried copy tftp flash: but I keep getting no such file or directory.Mike
Which command configures directed broadcasts on an interface?A. ip int broadcastB. ipv6 unicast routingC. ip helper addressD. ip directed-broadcastany idea regardsNeo
I receive this message when booting my cat3550.I have tried to load different images but no success :(Can you helpdesk please?Would you like to enter the initial configuration dialog? [yes/no]:=== Flushing messages (00:00:42 UTC Mon Mar 1 1993) ===Ci...
I have a reflective access-list in a switch doesn't seem to work. What I want is allow our campus traffic (141.225.0.0/16) to flow freely, and block outside traffic come in except for certain users. Allow inside network (141.225.216.0/24) to go outsi...
I have a Cisco 6509 w/ Sup II that was configured for TACACs. This person is no longer available. SO when we reboot the switch and try the break key does not do anything. We cannot log into the Switch to make any changes, thus getting into ROM MON...
