when adding the varience command on eigrp, do you just add it after the network you have added or does it just basically double etc the metric of the fastest link ?
Is there any way of getting any utilization reports from my switches, and is there any way of getting an ip address of whats plugged into a particular port ?thanksCarlos
Can anyone please tell me how spanning tree decides where to block a certain port, and also how would I change this port so I can block the port on my choosen switch ?thanksCarlos
I have seen on one of my routers, an ip route where half the subnet goes to one router and the the other to another router, this is done by applying a mask, it was something like ip route 172.19.54.0 255.255.255.0 x.x.x.x, and the other route was 17...
We have a 3000 user cisco network which is essentially a core 6509/dist5505 /access model. Network bandwidth is nominally low useage and there seems plenty of backplane and BW generally to support user demands. However - we get on a daily basis occas...
Hi guys,Is it possible to adjust the 6500 line cards strict priority queue size? Most cards assign 85% of thebandwdith to the oridinary queues and 15% to the strict priority queue. It seems that it is not possible to adjust the size of the strict p...
I have a 827H that the IOS screwed up on. SO i reloaded it with the same image and when i reload the router the CRWS doesnt work on it. Can anyone help.
My Cat 3550 is EMI switch, but I cannot enable ospf on my switch:SW2#sh verCisco Internetwork Operating System Software IOS (tm) C3550 Software (C3550-I9Q3L2-M), Version 12.1(20)EA1a, RELEASE SOFTWARE (fc1)Copyright (c) 1986-2004 by cisco Systems, In...
Hi All,When all the traffic running on the primary link, can observe one way traffic on the backup link. Bidirectional traffic on the backup link only can be observed when primarly link manually shut down.My Question is: During what kind of sitiona w...
Dear NetPro,Does anyone can share what's the LC connector GE and SC connector OC3.i understand the LC connector and SC connector . but, just in doubt about the GE and OC3 only.kindly reply, and your reply will be highly appreciated.Regards,Jack
Hello,I am looking at the possibility of deploying GLBP in our environment and I am looking for feedback, either positive or negative, from engineers that have deployed the protocol in their infrastructure. Any feed back - success stories and/or gory...
Hi. It is a emergency situation.Our Internet Router 4500's ios has been corrupted by electicity failureWhen I boot up a router, I see a rommon mode.I know a various method for upgrading Router, Tftp, xmoden, But. This Router's rommmon doesn't find an...
I've read that in order to use Dynamic VLAN assignment, the enhanced image is required, but I've seen in other places that only the standard image is required. What is it? And how can I tell what image I have and whether this will work? I have the...
I'm new to this so please forgive my ignorance. My question: How can I set up two VLANs that maintain security between the two (VLAN1 cannot access VLAN2 and vice versa). We have a Cisco 1721 router (ver 12.3) and a HP Procurve 2524 switch in the ...
