Other Network Architecture Subjects

To all Professional,Did anybody try to install flash memory with different size in Cisco 3660 routers 32MB in Bank0 and another 16MB in Bank1. Somebody told me that it is possible to use this configuration but I am confuse. Cisco is not recommending ...

Though EIGRP has so many good features like unequal load balancing ,fast convergence & 100% loop free then also many ppls use OSPF as IGP instead of EIGRP .Which are those key points which leads OSPF. regardsSAM

I need some assistance in LAT. I have not been able to find any good documentation on LAT. At one customer site they are having network connection issues with several VXTs that connect via LAT to get to a VMS system.Are they any ways other than put...

Problems getting 2610 eternet interface and Linksys switch ports to run at same speed and duplex. When i set both device to run at same speed and duplex or use auto, When i check their running different. When i connect a cat2900xl switch with 2610, ...

Has anyone come across a problem with a Cisco 837 Router failing to auto-negotiate with an Ethernet connected Switch on the Speed and full/half-duplex of the connection?It appears that I have a problem where an 837 can ONLY auto-negotiates, and when ...

Can anyone tell me more about the IDS module and what it essentially does?Im also looking for a basic intro into the SWITCHING FABRIC MODULE.Please help..Kai

I have 2 networks joined by a T1 with a 1720 on each end of it. I use a W2K server for dhcp and have 2 zones created for each network. One is 10.10.10.x/255.255.255.0 and the other is 10.10.20.x/255.255.255.0. I can't get the .20 network to use dhcp....

I am still having some difficulty with a bgp configuration. I have a single router with two SPs. The SPs want to ping their respective interfaces. Echoes appear to work from some Internet locations to one interface, and from other locations to the...

I'm curently running a 5500 with the following IOS on the RSM module.IOS (tm) C5RSM Software (C5RSM-ISV-M), Version 12.0(6)W5(14) RELEASE SOFTWARE The other day I lost network conectivity and looking through my logs I noticed the following:Oct 9 22...

Hi,I have a 6509 with: 1 2 Catalyst 6000 supervisor 2 (Active) WS-X6K-S2U-MSFC2 SAL0611141M 3 8 8 port 1000mb GBIC Enhanced QoS WS-X6408A-GBIC SAD043501A4 4 48 48 port 10/100 mb RJ45 WS-X6348-RJ-45 SA...

Hi,I have just started to learn about IS-IS.Utterly confusing for now.I'd ask the network engineers outthere for their opinions in relation with that protocol -where is it typically encountered, what is the future of it, what is the recommended lab s...

I have 4x 100/full fibre links between 5509 switches. What is the best way of monitoring the utilization of the entire channel. We are usning HP openview. We are running Cat5.5(18) and IOS 12.05 on the RSM.Thank EP

I have several 2950s installed in the last 10 months which I configured with IP address, gateway, DNS, time and date, location and disabling spanning tree. But some of the switches lose their time and date and DNS settings so they've reverted to the ...

Catalyst 6500, Sup 2, IOS 12.1(13)E. I can't seem to find a command that will provide the same details.Any help is greatly appreciated.Ariel

Can the 2900series and 3500 series switches support on the IPX protocol.?