Other Security Subjects

hi i have doubt regarding the ip protocol no used in the failover messages sent between the firewalls through the failover cable. in some documentation it's mentioned 105 and in some 8 or 9. can someone just pls confirm abt the protocol no used . seb...

Hi All,I have had success using this forum previously, so hoping someone might be able to help again!We are deploying CSA (basically to sue as a firewall) to a number of our remote access laptops. For security reasons the default state for the CSA ag...

Can anyone update me on their experience in updating their FWSM to a new code image using the cf5 application partition? I need to update my FWSM from 2.2 to 2.3.3 and I was considering updating the cf5 application partition first, and then booting i...

We have a VPN3005 configured to authenticate WebVPN users via Active Directory. Unfortunately, users with a UK pound sign (£) in their password cannot successfully authenticate. Short of asking them to change their password, does anyone know of a way...

I am experiencing slow download speed when downloading WMV files across a 525 pix running version 7.1.This only occurs with WMV as other Http traffic is fine.what couls be the possible cause of this.

I am trying to install Version 5 CSA and have a big problem.I have build a Windows 2000 server and installed VMS 2.3 and all is well.But when I install CSA 5.0 after the reboot and I try and log back onto the server .. everthing is locked up.. everyt...

I am looking at create a sub-interface from a physical Fast ethernet and then implement IPSEC on the sub-interface.I had implemented IPSEC using physical interfaces before but not sure if there is any known issue with subinterfaces?

Hi All i have set up a site to site vpn on my ASA, i have no issue pinging the external interface of the remote watchguard firewall. when i try to contact the internal host by ping. i received a ttl expires in transitI will just like to know what doe...

Hi allI am back to where i am againafter configuration of the spilt tunnel command on my ASA, i was able to access Internet using my own connection from home after dialing in with the VPN client, but now i cant seem to access the company internal ser...

Hi there. I'm trying to configure an ASA5510 with no luck.My network is very simple. Computers on the inside with a single router connected to the internet. Use NAT to protect inside addresses and allows access to cetain machines with static addresse...

I'm a new user and can't quite figure out how Mars "sees" things; e.g., worm attacks, strings in packets, etc.It is not a gateway thru which all traffic passes ... it just sits there and looks at devices and therefore cannot examine packets.Does it,...

I'm wondering does the Cisco Secure Desktop come bundled with the ASA5510?I can see config examples of the ASA pushing out CSD from it's flash but haven't seen it clearly stated if CSD is an extra-cost over the ASAthanks

dears, can i Add secondary ip address to 506 firewall interface to support two different network

Hi everybody,I’ve a few questions about firewall (ASA) designing. Attached is my connection diagram.1. Can I use L3 switch as default gateway for PC and add 2 default static routes to both firewalls on it? Does it have any problem about route back pa...