Routers - Small Business

Hi,I built a network with many RV042 routers as client networks and one main RV082 router as host network. There are gateway to gateway tunnels between them. Every client router is connected to main host router. Host router is 192.168.100.0/24 and cl...

last year our Nework Security Supervisor submit hes resignationand unfortunately did not endorse us the admin password we already tried the passwordhe suggested when we contacted him but nothing of them works.Is there anyway we can reset the password...

I have a curious issue on a customer site where the above components are installed.The issue being that the iPhones the users utilise cannot connect to the mail server via WiFi, they are forced to connect with their 3G connection. The core issue seem...

Hello all, I am working with a Linksys RV016 VPN router v3.0.2.01-tm, I have been unable to get a client to work with this device. My first attempt was with the QVPN client, after sever hours working on the issue I was not able to get past the "Verif...

HelloI am getting this error when trying to edit QOS / Profile binding. I believe it appeared after I added a second VLAN. Firmware Version:1.0.3.10Firmware MD5 Checksum:6300e6c67223a4821c117504dc7ad6d6PID VID:RV120W-E V01Any other suggestions than f...

Hi,I'm having a problem with Dual-Wan load balancing on the GV042G.We have 2 DSL connections and would like to load balance traffic between them, however we keep having problems with lost connections.This seems particularly noticeable with things lik...

I have configured 2 VLANs 1 for internal and one for "guest" access each with their own Wifi Access Point.I would like a few IPs from the internal network available to the guest network such as the network printer.The Internal network is 10.10.10.x (...

I have my guest network setup according to the documentation supplied by Cisco. When I connect to the guest network and open up IE, I am prompted to enter the passwork. I enter in the password and nothing happens. The page is just blank. When I exit ...

Dear Team, This is my first post   correct me if am wrong. We have RV042 router in client location (indonesia) and we accessing from Bangalore, India. My problem is we had configured Port forwarding Wan1 to 192.168.1.10 and 11 and till yesterday it w...

Hello community,is it possible to use the DDNS feature (dyndns.com) behind a 2nd NAT router?Network is as follows:INTERNET - NAT-Router (unknown device) - Cisco RV-180 (NAT) - ClientsKind Regard,Michael

I have two RV042 routers connected and configured for VPN by the book.  The office site subnet is 192.168.1;  The factory site is on 192.168.2.  They have been working flawlessly for three months until yesterday. Now I cannot:ping either subnet from...

One day, my rv042 started emitting a very high pitched sound.  The lights will flash upon powerup, but not act normal (indicate link, etc).  The router cannot be accessed at all.I changed the power supply to a known working one to eliminate that--did...

Hi everybody,For some time now, we install Cisco RV180 in front of our IP Phone System. these are Linux box with Asterisk software on top of with. Everything was fine fine, but we time, we came to beleive that there probably is somthing wrong in the ...

I tried some online free Syslog server tools but fail to get router's statistics anybody can help me to create a Syslog server on my Windows 7 machine.

Hi!I have the following situation:I have a RV082 router connected to internet. Because we are changing this router with pfSense to get vlans working, I'm doing a step-by-step change. As I have another RV082 router, I'm trying to connect to my gateway...