Routers - Small Business

My RV042G Gigabit DUAL WAN router currently has Firmware version v4.2.1.02 (Jan 18 2012 14:10:55).  There is a new firmware listed for the RV0XX routers, and it lists the RV042G as one of the routers this updated firmware is for, but it also mentions...

I have an RV180 wet up as the main router in my office it is the DHCP server and link betweek the netwok and the internet via a 2wire 2701HG-B Gateway DSL modem. The modem is connected to the WLAN port on the RV180W and is set to the RV180W in in a D...

Hi,I updated our firmware for the RVS4000 to V2.0.3.2. All looks fine, and after reconfiguring the settings (from  default) I logged out and re-logged in ...Well that did not work ... it turns out that the new firmware does not accept a change in pas...

I have a SRP521 router used mainly for security (VPN access). This router has a 2 FXO slots and one FXS slot.Documentation shows how phone device connected can make calls through SIP server, and this workI would like to make VOIP calls from the outsi...

I tried any type of combination and just couldn't make it works.  Only PPTP works well.  Can anybody tell whether Apple iOS IPSec VPN is supported or not?

I had set up rv042g to Smart Link Backup mode. but sometimes wan1 link is "flashing". E.g. it has short time link downs which may last for a loooong period. And every time wan1 is up, router switches back immediately. this leads to fully unworking in...

I have been trying to get the RV110W to place all VOIP phone data at a higher priority than other internet data. I have tried to connect all the phones to a seperate switch and connect them to port 3 with everything else on port 1. Then I have place ...

Where can I find simple instructions on getting this to work? It seems so straight forward and yet it refuses to work. What I've tried:1. Added a new Vlan (5) and assigned it 10.0.0.12. Added a new Zone and assigned it to the new Vlan and assigned it...

Hi,I have a RV082 Router, and when I try to connect to wifi it reads not in range. Can someone please help me figure out how to fix this issue?

Dera SIR,where i can download the last version orf RV042 with protec trend net

I recently purchased two Cisco rv110w wireless internet routers.  I want to configure one rotuer as a remote office while the other is the home office.  I would like all traffic from the remote office to be routed throught the IP sec / VPN tunne with...

Firmware failure on the rv042g router. I am unable to access the web interface, and holding down the reset button appears to do nothing, (unplugging holding the reset down and plugging it back in while still holding the reset until the lights flicker...

Hi.I have a Vpn tunnel working between two RV042 but i can't passtrough this tunnel.VPN Passtrhough are all enable.What is the IP address that i have when i came out of the distant network?how can acces to the distant network?Thanks.

I had high hops for rv120w, apparently, i didn't do much research on it before putting my hands on it. I use it for hoe wireless networking and to connect my xbox to internet. Here are my problems ;-- The WAN will suddenly drop and in logs i see inte...

I've read a number of forums which suggest that the DPQ3925 does not support the Bonjour protocol and as such devices such as TIVO will not work on it. I can discover the devices by typing in their IP address, but software that i usually use (Toast 1...