Routing

Hello, I have connected up a new ws-c3650-48td to a WS-C3850-48P via Gi1/1/1. The new switch simply has two vlans i.e. vlan 20 for all of the 48 access ports and vlan 200 for switch management simply via an SVI interface and a trunk uplink allowing b...

I have Cisco 881 router  having issue with port forwarding  only one port forwarding work 192.168.100.10 with port 4525 if I remove NAT pool then only port 8000 to 8002 work here config file   !boot-start-markerboot-end-marker!logging buffered 15000 ...

Hi All,I tried to copy my conf file to a USBflash drive but I cannot initialize the USBflash drive.It asks me to format the USBflash, but when I say "yes" it gives an error.Feb 21 11:18:40.799: %USBFLASH-5-CHANGE: usbflash1 has been inserted!Feb 21 1...

Hi All experts, I am trying to understand a difference between E1 and E2 routes in the OSPF. Please help me to get in technical deep in this topic.   Regards, Deepak Kumar

Hello. Many days trying to solve the problem. Help me please.    Route Reflector - Cisco 3945 (ip 172.22.128.128) Client - Huawei S5710-EI (ip 172.22.182.190)   I need to connect my S5710-EI to Route Reflector (Cisco) via MP-BGP. Connection state up ...

Hello All,    I've recently purchased a few 1841 routers for a home lab while I study for my CCNA.  The routers were purchased off of eBay, and all of them were locked and requiring login before getting to a command line.   I was hoping it would be a...

I have a 100MB Charter WAN connection between two locations.  We are plugged directly into the Cisco Equipment provided by Charter.  One location has a 1921 Cisco Router and the other location has a 2921 Cisco Router.   I have been using iperf to con...

I need to add a few static route to an MPLS router running BGP, and I would like these static routes be advertised to the rest of the MPLS NetworkThe current BGP configs are as follows: router bgp 64444 no synchronization bgp router-id 10.0.3.1 bgp l...

Why don't the Cisco CCNA and CCNP programs cover ATM? I see this technology used everwhere. They seem to spend more of the training on Frame Relay.

Hello,    Can someone explain to me what does mean the following commands please :    mls qos map cos-dscp 0 8 16 24 32 46 48 56mls qos srr-queue output cos-map queue 1 threshold 3 5mls qos srr-queue output cos-map queue 2 threshold 3 3 6 7mls qos sr...

Hi,   I just would like to confirm my understand correct due to I have to use remaining 10GE port on line card WS-X6708-10GE with sup720 in the customer existing device.    - I can use it all 8 port 10GE in WS-X6708-10GE line card but it is not provi...