Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Labels

Forum Posts

Just a quick post to confirm my understanding of MPLS. We have a couple of ADSL connections and our ISP have given us an IP address of 192.168.200.x for our ADSL routers. The MPLS routing is static for these routers. Now, we are obviously peering int...

louis0001 by Level 3
  • 1411 Views
  • 0 replies
  • 0 Helpful votes

Hi, We are running Cisco Prime infrastructure version 3.1.0 with 3.1.3 maintenance release installed(Are we then running Prime version 3.1.3?) When you look in Vsphere on the machine it says the following of the VmWare tools - Not running, version:1...

i want configuration Cisco 2921 (OS version 15.3) router local user password policy, however i can do it, there is no this command under AAA "aaa common-criteria policy policy-name " but this command work on switches. i reference this configuration g...

I'm looking for config validation and any improvements or recommendations for the following scenario:   2x Internet Routers running HSRP each are connected to a different provider, receiving default routes.   One will be the primary active and the ot...

Hi, I have Cisco 881 with SIM card and I cam not able to ping the internet. Could you please advise? My config is below, it is full of garbage because I have already tried to find a solution... :(   Current configuration : 3131 bytes ! ! Last configu...

Phil007 by Level 1
  • 12746 Views
  • 18 replies
  • 0 Helpful votes

Resolved! IWAN Transit sites

I'm reviewing the architecture of a two Datacenter IWAN deployment and realized we have a master transit router in the mix.  I had previously thought that we only needed a backup hub master controller in our second datacenter, so when the primary fai...

pdub206 by Level 1
  • 1617 Views
  • 1 replies
  • 0 Helpful votes

Hello Everyone,   I have a quick question. I'm new to cisco packet tracer and not very good at configuring the routers and switch with each other... (Is it possible to connect 4 routers with one switch? ) For example For Router A ( the IP 202.120.8.1...

Oz1 by Level 1
  • 19077 Views
  • 10 replies
  • 0 Helpful votes

We just replaced our core and are having an issue with our VDI environment.   The ip range for these devices is: 10.240.0.100 - 10.240.5.254 Subnet: 255.255.240.0   If a VDI device boots up and pulls one of the 10.240.0.x addresses it connects and wo...