Hi Guys, I have a new cisco 887va-k9 with two port of the four with a POE connection. The question only is, how do I turn those?there is no seperate power supply at the back as the old versions.Thanks for advice. Gr Daniel
Hi,
I should say I've had this problem before and it was resolved using interface Wlan-GigabitEthernet0/0 switchport mode trunk. This is on another router and it's not working this time. I've attached the config files as both would be too long. I fol...
We have just installed our first 2951 router, and were suprised to see in our Netflow collector that Tunnel interfaces appeared even though wedid not configure any, I have seen other posts talking about PIM tunnel when using Multicast, but we dont us...
Hi All,
I am trying to set up a site-to-site VPN between an RV130 at a remote location and an ASA5505 in our main office.
Unfortunately the link won't go up. On the ASA side I see "IP = 79.33.131.15, Error processing payload: Payload ID: 1". This I...
We've been receiving this log message on an ASR100x:
Aug 8 14:32:19.292: %IOSXE-3-PLATFORM: F0: cpp_cp: QFP:0.0 Thread:046 TS:00004977608472352025 %ATTN-3-SYNC_TIMEOUT: msecs since last timeout 4977561996, missing packets 114668
Shortly after thi...
I have an existing ACL that is not built using object groups but would like to create a network object group with a list of networks and add it to this ACL.
Will this work or do I need to completely rebuild the ACL using groups for all services and ...
My VS-card is keep crashing the IOS after using all the latest versions and older versions as well, can anyone suggest what i need to do? it is going till downloading mode when i press no for configuration. THEN AFTER THAT IT IS KEEP RESTARTING AND G...
Hi!
I have Nexus 3064 and Juniper MX960 devices.
Have the same configuration on Nexus:
interface Ethernet1/48 description access-switch-S2326 switchport mode dot1q-tunnel switchport access vlan 303 speed 1000
interface port-channel1 description -=M...
Hi All,
I need some help..
In my corporate network (office-A), there is one application server & NATted public ip to access clients from Internet. Now planning to move this application server to different network (office-B). Due to some constraint, t...
Hello Community / Hello Everyone,
I would like to know if you come across any 800 series router what it has more then 8 Vlans..
Previously I used an 887va and an 881, but I would like to find "some" solution. Our network just about to upgrade from ...
Hi,
I suspect my router is having high cpu utilization as response to ssh and telnet is slow, also response to execute commands is slow.
I did a "show processes cpu sorted 5min"
Can anyone please explain the results of the "show processes cpu sorted ...
Hi,
i am doing Natting on Cisco router 4321.
for LAN users i am doing dynamic Nat.
ip nat inside source list INTERNET interface Dialer1 overload
ip access-list extended INTERNET
permit ip any any
customer also want to access CCTV from out...
Hello
We recently ran into bug CSCus64795 on one of our Cisco 6509 pairs (Excessive logging/Memory leak due to a parity error in the Netflow VRAM) and forced switchover to the secondary VSS unit. Please would someone advise how long a VSS switchover...
