Routing

Hi,     we going to purchase ASR 1001 with ipbase, BGP is our basic requirment if we purchase ipbase(SLASR1-IPB) it will support BGP, kindly suggest also find my bomProductDescriptionASR1001Cisco ASR1001 System,Crypto, 4 built-in GE, Dual P/SASR1001-...

Hi Experts recently one of customer shared their QoS Plan for upcoming network and mentioned that they are going with 8 tier QoS model..something like below example : Tierapp nameclassDSCPCOSbw8VoipEF465207video type 1 CS4,AF4132,344,4236streaming v...

Hello World basically I've got 2 internet connections on the same 881 router. I want my lan to use wan 1 but a specific host on the same lan to use wan2. wan 1 is a physical interface fa4. Wan 2 is a vlan with a static ip address assigned to one of ...

Hi Guys - It is a general question about WAN Link utilization. I have 20 Mbps MPLS Link from service provider 1) Whether the MPLS links are in Symmetric or Asymmetric? 2) Whether the user can simultaneously upload data at the rate of 20Mbps and downl...

Dear All, I have a Cisco 2821 with a HWIC-D-9ESW card. Router is enabled with multicast ( globally ) and some interfaces are ( including HWIC ports ) enabled with ip pim sparse-dense-mode . My Problem is there are ports sending muilticast traffic eve...

Is it possible to Split a SM-D-ES3G-48-P into 3 switches without using a vlan?

Hi Dear, I have 2 ISP (WAN) connectivity. I want to terminate those connectivity simultaneously or by load balancing in one cisco router. Which cisco router I can use for these connectivity. Please suggest the router and possible connectivity.

I am using a IE2000-16T67P-G-E switch and I need to know the part number and maufacturer that makes the mating connector for the console port.

I have a switch, with vlan 100, 101, 102. vlan 100 172.16.100.1/24 vlan 101 172.16.101.1/24 vlan 102 172.16.102.1/24 I have ping from a internal host for example: my host 172.16.100.10 ping 172.16.100.1  correct ping 172.16.101.1 correct ping 172.16...

Hi all, I am going to replace a router into a new model 1921. But, on existing router, there is a module "VWIC2-1MFT-T1/E1". I am planning to put this module onto new router. Is there anyone know did 1921 support "VWIC2-1MFT-T1/E1"? Thanks, Bell

I'm thinking about adding a circuit from another internet provider to our environment, to provide some backup in the event of a failure and, hopefully, to share the load a bit when we're not in the middle of a failure.  I'd really like to find a way ...

Hello community,I would like to know if it is possible to implement the PFRv3 technology without involving any branch site. Just allow HUB users to do load-balancing and MC path control router? thanks in advance

We are trying to establish eBGP multi hop but it is not working. HEre is the sample config. router bgp 1111 bgp log-neighbor-changesneighbor 208.110.23.246 remote-as 2222 neighbor 208.110.23.246 ebgp-multihop 5 neighbor 208.110.23.246 update-source ...

EIGRP key-id on cisco ASA's can only be between 0-255 , whereas it's much much higher on the Router's.  We are planning to implement EIGRP on cisco asa's to move away from static routing but realized that key-id on the router's is greater than 255 wh...