Routing

I placed a 2mft controller in an nm-hdvwith 2 resident t1 controllers. The origial controllers have frame. The first controller on the new card is PRI.When I tried to set up the 4th for T1 Irececived msg "Not enough HDLC resources(0)" Has anyone had ...

Is there a way to make hierarchical traffic shaping work on VLAN interface on Cat6500 with SUP720? I understand that traffic shaping is not supported by PFC, so we issued "no mls switching" command and from "show policy-map interface" I see that pack...

Hi,I have question about policy-routing with regard to next-hop ip. Does next-hop ip have to existed in the Cef/fib table for policy to work?.Reason being is that if I make next-hop ip via address learn from routing table I get policy reject and rout...

Consider the following scenario:Not sure if the ASCII art will come out. PPPoATM PPPoFR7200 NP-G1 PA-A6---------------------------FRF.8---------------------------WIC-1T 2811Nested service po...

I saw a GRE Tunnel configuration and i would like some advice. There is loopback interface loopbacko configured. There is a tunnel0 interface configured with ip address in different subnet and tunnel source pointing towards loopback0. How GRE Tunnel ...

Hello All:Have an issue and am not quite sure of the cause. Segmented network, 1.x, 2.x, 3.x Have a 2600 Router servicing the 3x clients for internet connectivity.FA0/0 ip address 10.0.3.1IP NAT insideThis interface used as gateway for 3.x clients to...

HiI am trying to configure the Cisco 7603 as a IPv6 stateless DHCP server & 7204 as client. I am not sure what I am missing in the configuraton. Following are the configuration from 7603:interface GigabitEthernet3/1 no ip address ipv6 address FE80::1...

We have a single router on our LAN that is for third party connections. I want to run OSPF for these connections so that the routing is dynamic. However I want to stop each 3rd party receing eachothers networks - what options do I have??

Hi All. I'm a budding CCNA (i.e. not as experienced as I'd like!). We had the above supervisor fail last night, we've put in a new supervisor - but neithert my boss or myself has had to do this before. The hardware side of it is done, the old flash...

Hello Guys, Please find the attached file to understand the scenario and problem.Regards,MAX

HelloI have installed v.35 card (PA-8T-V35) with octal cable. The problem is this that i cannot see 'show controller' information for serial ports. 'show contrller' support only this:Router#show controllers ? E1 E1 controller internal state T...

Do you know if there are any ready-to-use network documentation forms to download?

Hello GuysI have Cisco 1721 Router and have one serial and one Ethernet port. when i configure following commands for rate limit by trying on both the interface ( Serial and Ethernet) one by one rate-limit input access-group 110 25000 2000 2000 co...

Can I transport ethernet frames on frame relay PVCs ,, I know FR is WAN technology but is there any wayout to interconnect Ethernet over frame-relayRegardsfaraz

I have 2 routers, Marvin and champion. Both connected via Internet. But, Champion, 192.168.3.0 subnet does not seem to be able to browse Internet. Why?Marvin Routerinterface tunnel 0ip address 10.1.1.1 255.255.255.0tunnel source 203.1.1.1ip nat insid...