Routing

Can someone explain where the auto tunnel's bandwidth is derived from, and what significance its utilization might have?  The output of sh int tu0 seems to indicate that lo0 is the source, but their values are very different.  I noticed on one of our...

Hi Guys, I am slightly confused by the lab I have setup in GNS. My ibgp neighbour seem to have local preference of 100 by default so I would expect that to be picked rather than my ebgp which has local pref of 0 why is ebgp still picked? isn't lo...

I have a customer who is trying to setup an ISR4331/K9 with the 4G adaptor using an EE Sim. This is for a 'Try & Buy' before rolling out to the rest of the organisation. They cannot get it working correctly and below is the problem as raised to me. P...

Hi  I am seeing 0 bits/sec output rate whereas the around 26Mbps traffic ingress to the interface.  What does it indicate? How the return traffic is not showing as output packets? 5 minute input rate 26319000 bits/sec, 3017 packets/sec 5 minute outpu...

i have cisco router ASA5505. I am just trying to find out whats the ip address for this router??

So there is this simple GNS3 topology. The host is Ubuntu Linux tap0 interface. ifconfig output: tap0 Link encap:Ethernet HWaddr fe:6b:25:17:ab:af inet addr:192.168.2.2 Bcast:192.168.2.255 Mask:255.255.255.0 inet6 addr: fe80::fc6b:25ff:fe1...

Describe how Data Encapsulation works with the aid of diagrams

As per my requirement, I have to Police traffic coming from my Branch Network to the DMVPN HUB device. My DMVPN Hub is connected to Core. I am trying to implement Policing in Egress direction. When I am putting the required configs then I can see tra...

Trying to understand why connectivity response would change from a simple shut no shut on a few interfaces on a 2960 24 port switch. Summary: Three Win 7 computers serving cash register functions are connected to interfaces on a 2960. Cable lengths...

I Have two Routers (Cisco 2821) connected one at my Main Office & Other at Branch Office. I have taken two MPLS Link from two different Service provider and created GRE Tunnel using MPLS Source & Destination IPs. Now I want to merge bandwidth of this...

Hii, We have one branch with bandwidth of 512 Kbps, we want to prioritize traffic like below First priority - Citrix traffic Second priority - Mail and all other traffic Now my question is that " Bandwidth" statement under QOS config is applicable ...