Routing

Hi, not sure but this could be a specific ASR9K required configuration to allow me to get prefixes from two neighbors downstream? I am attaching detailed information. Can you please let me know what  I am missing here? RP/0/0/CPU0:ios#sh ip bgp summ...

We have an ISR2921 working as a voice gateway, and we can connect to an ISP thru a SIP connection.the SIP provider give us an username/password and SIP domain of SIP proxy server, how to use the user account to register to the SIP provider? how is th...

I have an ASR1004 running an image prior to 3.10 and I'm trying to find the documentation to upgrade it to: asr1000rp1-adventerprisek9.03.16.01a.S.155-3.S1a-ext.bin REDUNDANCY MODE NONE I've looked at http://www.cisco.com/c/en/us/td/docs/routers/a...

I am trying to set-up a cisco 2960-x switch as layer 3   i have 3 interfaces configured  Vlan1 - 10.7.1.1 - 255.255.255.0   Vlan99 -  66.227.98.98 255.255.255.224 Vlan22 - 172.31.255.6 255.255.255.248 Vlan22 is my VPLS Traffic - work 100% - On Gi1/...

Hi Team, How could I identify where the tail drops happened ? System image file is "bootflash:asr1002x-universalk9.03.13.02.S.154-3.S2-ext.SPA.bin" show plat hard qfp active statistics drop-----------------------------------------------------------...

Hi GuysI am having serious  issue on one of the spoke.there is an adsl connection on spoke and tunnel keep going down .same config on other spokes having adsl connection have no issue .(there are few drops when ping 8.8.8.8 from spoke router sometime...

Hi all, I post this to ask "how to redistibute management interface on BGP" basically, when execute "redistibute-route direct" under bgp configuration, managemnet interface ip address is not included on advertisemnet packet. right? if I want to redi...

Dear Experts, I need help on below topic. Working for two data centers. In one data center, total four Nexus 7K's are installed. One Nexus 7K pair function as access/aggregation & another Nexus 7K pair functionn as core switches. In another data cent...

hi Experts, I have 2 sites which i have connected using fibre and microwave link. but i am unable to configure the failover. Am not good at configuring Cisco routers so i need someone to elaborate to me how to do it step by step. i want that when the...

I am facing issue with ASA  Traffic from Inside towards Outside interface is not working properly. 1. If I ping Lan device to Inside interface of ASA (Locally Connected) I am getting replies. 2. But if I ping LAN device to Outside interface of ASA t...

Hello I have a list of devices that have Smartnet contracts associated but the contract is not linked to my account. Con you link the contract with the devices attached to jmoneta@globalsteering.com