Routing

Hi, all. For a few months now my Linskys e2000 wireless router has been sending a very weak signal. It's even weak when I'm sitting a mere 12 feet from it. And forget walking down the hall and into the other part of my apartment. Lots of 4G data bei...

Hi, I'm trying to upgrade to an ASR 1001 but throws me the following error Router#issu loadversion rp 0 file bootflash:asr1001-{rpaccess,rpios,rpcontrol}*03.16.01a.S.155-3.S1a-ext*.pkg bay 1 force--- Starting local lock acquisition on R0 ---Finishe...

Any thoughts against using a 4500X in place of an ASR1001 for simple BGP?  What am I losing by using a 4500X rather than an ASR?

I am using BGP conditional route injection, so am familiar with it... http://www.cisco.com/c/en/us/td/docs/ios/12_2s/feature/guide/fsbgpri.html http://blog.ipspace.net/2015/01/bgp-deaggregation-with-conditional.html I am using it as an inbound policy...

Dear cisco, We have Cisco 1941 with ADSL card, we need config this device go to internet via by ADSL, after doing the configuration, the ATM is up, dial 1 up, but it not receive IP Address and not connect to the internet, below is my configuration: B...

hi,i was checking today the document "Troubleshooting High CPU Utilization Due to Interrupts". This talks about cpu load due to long access lists and also talks about using netflow switching with CEF to improve the process of access list and switchin...

Hi, we have leased line between our data center to branch office as a primary source of data access. also we have separate internet links in data center and branch office. is there any way we can create a VPN between these two locations by using inte...

I am having trouble setting up my backup link in my 2911 router.  I have a the main link activated, but when I put in the fail over IP address, it dones not route out.  Any help is appreciated.

Can I use SVI IP address on a C3750x as a BGP neighbor address?  The router will be directly connected to the C3750x interface that will be configured as a trunk port. 

Team , I am using VIOS for switch configuration ,my problem cannot save the running config . when I open devic again, all the existing config are deleted. Please give the solution for it.

Hi everybody, We have connectivity between two sites one with a 4/4SHDSL connection, the other has 2x 2048/384 ADSL connections. We are using GRE tunnels and EIGRP to load balance.We are currently being shaped at the proivider edge out to the site ...

Dear Ladies and Gentlemen. We bought a WS-C3560G-48TS-S Switch on the 15th of july 2010.After a power failure the switch never goes online, only the "SYST"-LED lights but no connection or remote access is possible. Do you have any ideas how I can get...