Routing

Hi, just bought Cisco RV325 and trying to connect to Modem. At first, PC connected to LAN port can access to Internet, but somehow the router now can not access to internet with any LAN port, log in to router, I found that WAN status: connected with ...

Hi, just bought Cisco RV325 and trying to connect to Modem. At first, PC connected to LAN port can access to Internet, but somehow the router now can not access to internet with any LAN port, log in to router, I found that WAN status: connected with ...

Hi,I was wondering if someone can help me answer the following question. If I have a public ASN and I have multiple border routers peering with 2 of more tier 1 providers and also connect to another ISP over a private peering session, and I advertise...

Hi,I have encountered problems with GLBP.1. GLBP is not acting as Active/Active.R1(ISP1)glbp 1 ip 10.1.1.1glbp 1 priority 105glbp 1 preemptglbp 1 load-balancing host-dependentglbp 1 weighting track 1 decrement 100track 1 interface GigabitEthernet0/1 ...

The Door release is a Zenitel IPSTATION v2.0 ( on the web page it is called a Turbine IP-stationWeb)All teh documentation is for a call manager, not a call manager express.I cannot get the door bell button to ring the reception, the button does nothi...

I've got a Cisco 891 and I'm trying to configure the thing to connect to a 4x1 fiber connection.  I don't know much about PPPOE. Following this guide, http://www.cisco.com/en/US/docs/routers/access/800/850/software/configuration/guide/pppoenat.html B...

Hi Guys,I'm running an 867VAE-K9, ios version is 15.4(3)M3.I've been trying to apply QoS to the Dialer1 interface (PPPoE). The physical interface this is attached to is GigabitEthernet1 which is connected to a VDSL modem.class-map match-all WifiCalli...

I am testing out a new 4331 (15.4(3)S2) with securityk9 licensing enabled.  However, ip inspect is not recognized as a valid command.  Has this been moved to another license?  Or is there a particular service I need to enable first?  I'm not currentl...

hi allIt is just very simple questionIn order to use 4948 switch layer 2 mode, what can I do configure special?I think No configuring something I should do?and I think just inserting UTP cable to thr switch => L2 mode ,, is it right?Thank you all!

Hi. We have a site that currently has a satellite connection used by users, and a 3G connection used for a specific application. Connections are from different providers. Every connection has it's own router, switch and connections. Is there a way, t...

Hello everybody I am doing some test with this scenario : Terminal-Server_V24 ---> NULL-MODEM ---> Router1_V24 ---> Router1_V35 ----> MODEM1 --- /// --- MODEM2 --->  Router2_V35 ---> Router2_V24 ---> NULL-MODEM ---> Terminal-Server_v24 I have configu...