Routing

Hi we has Cisco ASR 1002-x that is connected to mpls cloud .we are having input errors on WAN interface gi0/0/0 and they are equal to number of giant Packets.since its on WAN side i cant put any sniffer, is there a way i can find out source of these ...

Hi All, We have a  WS-C6506-E with SUP720-3B do you know if IEEE 802.1Q-in-Q VLAN Tag Termination is supported?  If it is any idea what IOS I would need to run? Thanks!

I have setup a ssl vpn gateway on the ASA. The problem is when I first time to initiate a ssl vpn connection from anyconnect client, it will take 1 to 2 minutes. But after that, if I disconnect or cancel it and reconnect to it, it will take only 5 se...

We are having 10 mbps point to point dedicated leased line between 2 locations. We need a router which gives least latency. Our data flow is latency sensitive and each microsecond matters to us. Kindly suggest a router which will minimize the latency...

Hello, I am looking for any stable router for small office ( few servers accesible from internet ) for max 100 persons. I would like to give mobile users possibility to use VPN channels in more than 5 quantity. Is that possible? Would be best to have...

hello  i am trying to monitoring an 5505 ASA via the inside interface from a server that's coming from the outside. which keeps on failing but it works fine if i put in the outside interface as a destination. for the love of god i have been trying ev...

Hello, I have two routers working as main and backup via HSRP. Both of them are advertising the subnet 172.10.10.0/24, the question is I need that the packets with destiny 172.10.10.64/26 subnet, go through the backup router. I applied a route-map wi...

i have network like on picture. My network have two segment 192.168.200.0/24 where are my servers and network 192.168.0.0/24 where are my workstations. the workstations can go to internet over ISP-internet. How i enable that my servers also go to int...

Dear Team,Can anyone help me on the below switch ordering.We would like to order the below switch, however we need to know PWR-C1-BLANK and C3850-NM-BLANK are an included  items or do we need to order separately. Thanks for your help in advance. WS-C...

I have a blade configurations NLB  and I  had the issue of flooding Switching. Anybody do multicast mode changes and apply Cisco recomendations Configuring the COREmac address-table static vlan xxxx x port-channel interface WZarp [ IP address] [ mac ...

If we have Get VPN on mpls Link (many site)  and after We have implement Dynamic routing Such as EBGP communication between site (don't use GRE Tunnel)...It Possible ?? Traffic will be encrypt ???     Thank you.

Hi, I need to add a new ISP for redundancy, this ISP is now ready but need to configure a  VLAN ID in the wan2 portthe question is: is possible configure the VLAN ID in the wan port2? Best Regards, Tomás..

Hi All,We currently have an ASR9006 with dual RSP-4Gs that we are looking to upgrade to either dual RSP440-TR or dual RSP440-SE. I was just wondering if anyone has had experience of doing this. My main question is can this be done whilst keeping the ...