Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Hello,In our company, at the main site, we have a 800-serie router (router A). In our second site, we also have a 800-serie router (router B) thatconnects to router A to establish a tunnel. The network at B is 192.168.32.0 and the network at A is 192...

Hello friends, Imagine I have the following SVI's configured locally on a Nexus 5548... int vlan 10ip address 10.0.0.1/24int vlan 20ip address 20.0.0.1/24int vlan 30ip address 30.0.0.1/24 How would I temporarily prevent EIGRP from advertising vlan 20...

Hi every one,i am facing an overlap ip addressing scheme issue in my network.i am working in a SP type company providing service to the customer. a new customer want to connect me via my router interlace & his requirement is to connect with  the same...

gnkhan2 by Level 1
  • 430 Views
  • 1 replies
  • 0 Helpful votes

Hi,  We are trying to setup a tunnel between Location A and B (see diagram) to pass some traffic since our MPLS bandwidth is limited. However, I am not an expert at this type of configuration so I need help from the community. I am sure that more que...

Hello All.I am reading the following book and trying to practice with the topics.Implementing Cisco IP Routing (ROUTE) Foundation Learning GuideFoundation learning for the ROUTE 642-902 ExamDiane TeareOn page 34 of the book, under the heading "The IP...

jaighobahi by Level 1
  • 2485 Views
  • 12 replies
  • 0 Helpful votes

Can you advise the best solution for dual edge router, dual ISP connection.We need to load balance/share the connection. Our internal routing is OSPF.Is BGP peering to the ISP the best soution to load balance?If we just use default route on the edge ...

Unanswered Topics