Routing

Folks,I have attached a topology which we are looking to achieve for some routing design. Below are the questions: 1) We need that the P-2-P link between both the Data Center is used only by the traffic betweens the Data Centers.2) Consider a scenari...

Hey I am deploying a new VPLS between 8 offices. The plan in to have all the offices get internet access through the main office. So basically all the satellite offices will only have access to the VPLS WAN link. The main office will advertize a defa...

Hi All,PFA...I'm beginner to BGP & designed network like in attachment.I'm unable to ping R5 from R1. R1:!interface Serial1/0 ip address 20.0.0.1 255.255.255.0 serial restart-delay 0router bgp 200 no synchronization bgp log-neighbor-changes network 2...

Hi,I thought I understood summarization pretty well but I found an example on the Todd Lammle book which is confusing me and makes me think that I might be missing something.1. This first exercise asked to summarize 192.168.1.0/24 through 192.168.12....

Hi there, I have a problem with a policy-map on an interface VLAN on my Cisco 6509-E.The switch has the IOS Version 12.2(33)SXI10, RELEASE SOFTWARE (fc2). I have configured this policy-map:policy-map PM-10Mbit  class class-default   police cir 100000...

I use a 877VA for my VDSL connection How can I sync its clock to an external NTP time server without the modem itself replying to NTP queries from external users. I need it to sync but don't wan it open to NTP amplification attacks  

 Dear all  I want to configure this configuration snapshot from cisco wrt120 to cisco 877 router , 

Dear AllI read some documents regarding the order in which routing and NAT are performed at one edge router. But when we do routine work, we do not meet this kind of thing. Any one can give an example to explain it ? Thank you. Frank 

Hi all,Recently we purchaged a Cisco 819HG-4G router. Unfortunally I am unable to get the default profile 1 active.Local Dutch Provider is KPN. chat-script lte "" "AT!CALL" TIMEOUT 20 "OK"interface Cellular0 no ip address encapsulation slip dialer in...

As title. I need to remove a 10gb module SPA-1X10GE-L-V2 from an ASR1002 but I'm hoping I don't have to power down the unit to do so.Can this be done?Thanks 

Hello fellow networking engineers,I want to implement OSPF in our network. We have multiple branch offices, all linked to an MPLS backbone. I know that in order to get linked areas, I would need to setup GRE tunnels between them, but I want to avoid ...