Routing

Hi,I need help on how do I get features supported in this IOS s72033_rp-ADVENTERPRISEK9_WAN-M, version 12.2(33)SXH8a

What causes a high memory  (80 %) and remains high with the same percentage even after rebooting?

Hi,I never ran into this issue before and pretty much lost now...I know i configured console on a 3925 router to be no authentication/no authorization and it did work for me when I connected laptop to it before. But now I got Authorization Failed mes...

HiI am installing a product called Forescout CounterACT.  This product works by having traffic forwarded to it along an RSPAN vlan.  The CounterACT Virtual Machine will be installed as a Highly Available VM in a Hyper-V farm. RSPAN specifically targe...

Hi,My Problem is:If I initiate traffic for both outside NAT interface (G0/1 and G0/2) from NAT inside  interface G0/0 the NAT translation table for both interfaces will be established but only from outside interface  G0/1  targets got responses. If I...

Hi   I use 3 switches to create a topology of PVST+. However, I want to measure the convergence time for the topology if I block a link, I don't know which command or what kind of method I can use.  Use clock to calculate the time by hand or by somet...

I am trying to configure a Cisco 1941 router for connectivity to the Telstra NextG service using the APN telstra.internet.This APN does not require or use Usernames and passwords.The 1941 enforces the use of Encapsulation PPP on the Cellular interfac...

How often does the CEF table get updated on a 7604 router with 7604-SUP7203B-PS card and IOS: Advanced IP Services v15.1(3)S3 SSH - thanks!

If I have a route-map that is configured correctly, shouldn't I see packets and bytes increasing when I do a show route-map command?  This is what I see on all my route maps and I wonder if they are even working.Policy routing matches: 0 packets, 0 b...

Hello, As demonstrated on the network diagram:I have a 1841 connected on 2 ADSL lines on different ISPs with route maps & cefI have an 3650e switch connected on the router on a single interface1841 is connected to 3560e using 192.168.168.0/303560e ho...

I am currently having an issue on a large home network that I need some help with. Just as a preface I have just acquired my CCNA but my experience in troubleshooting real world scenarios is nill. So I am hoping someone could nudge in the direction o...

Good morning guys, I have an Access Point AIR-LAP1252G-A-K9 on my network and every time I try to insert a workstation that has installed windows 8 I can not and I have to remove the driver of the network card and install a version for windows 7. so ...