Routing

Hi,I would like to configure SMS / Email notification about Router wan link up/down. any one has done the setup please share the idea.we have sms gateway, Email server, and all syslogs are saving to syslog server.

 We have 2 Router 2951, both having 50mbps Link terminated on each router.Achievement - we have to do equal load balancing,at a time both wan link should be used and WAN Link Failover,Example - At a time both link should be used and if 1 link fails t...

Which regulatory domain should be used for Cisco AP AIR-SAP1602? We need to deliver them to Guatemala and El Salvador? For example we delvired AIR-SAP1602I-A-K9 to Argentina, Costa Rica and Paraguay. This was Regulatory Domain A.Could somebody help?

 Hello engineers,    our customer has a cisco 3750 router in which they configured PAT for internet access.  Total 500 users are sharing the 4 Mbps internet line ,Most of the time performance of internet access is good. But today the users are compla...

Hi, Can someone please guide me using Event MAnager Applet for following scenario. I have 2 WAN links. If one wan links gets down. Other link should get up. I tried by using IP SLA but i couldnt fine tune the vlaues properly. I want to use now Event ...

 I have a Network - 192.168.1.1/24. The range is fully utilized (all IP addresses are already assigned to hosts). How can I add 10 more hosts without changing the address or mask. Thanks, Manu

Is possible to configure wan load balance with 2 isp without bgp, with nat, using ios on 2911 cisco router? Different speeds of upload for each one..

I'm building a transit network with our internet provider terminating on a layer 3 switch. The IP addresses below are all made up. | ISP Router 1.1.1.1/32 | ---------- | Layer 3 Switch 1.1.1.2/32 | And the ISP will route our public range (2.2.2.0/24)...

Hi all,I am setting up a new 2911 with a ES2-16p switch module.  My question is, do I have to set up a trunk between Ge 1/0 on the router and Ge 0/17 on the switch if all traffic will be carried over VLAN 1?  I know this is not recommended usage, but...

I am very concerned regarding my setup options for this AP. What is the purpose in providing a GUI, if there is no documentation that demonstrates how to use it? While I am confident that given time and training I can become proficient using the CLI,...

I just saw a video where a guy had a Router, 4 Switches, and 4 hosts. In his topology, the Router actually was considered the Root Bridge for STP. Apparently the Router had a lower MAC Address than any of the switches. Does this sound right???

Hello,I carried out some performance tests between a Cisco 2911 router and a Linksys RV082. Specifically I tested the throughput of both devices in a Site-to-Site VPN context. What follows are the details of how I designed the tests. See the attached...

 Hi All, I have a 2801 which on which I see sudden rise in CPU util for approx 1 minute constantly close to 80%, by the time my monitoring tool tells me this and I login to check the reason its back to normal. So I enabled an EEM script to check what...

 Hi Experts,Can  u please explain the diff between ios,ios-xe and nx-os in architecture level or points me some gud articles on this topic?... I am trying to understand the difference between catalyst,ASR and Nexus devices.. Thanks,Arun