Routing

Hi,There is one client192.168.1.10and i want that this cklient to have web acces just on www.xxx.org and www.xxx.com and the others users have a web full access.I have made this:class-map match-any AUTHORIZED_URLS match protocol http url "*.xxx.org" ...

Greetings everyone,Here I am again, wondering about an aspect of OSPF.  Please, open the attached file. The image was snipped from Implementing Cisco IP Routing (ROUTE) Foundation Learning Guide. The following two paragraphs were also excerpted from ...

Hi everybodyI can see in my routing table 172.16.0.0/22 (learned via OSPF).I want to redistribute into BGP only a part of it (172.16.0.0/24).So far, I have not been able to do it with route maps or network statements.Any ideas?Thanks in advance

Hi, I am going through the book and came accross question below:Given the following partial ASA configuration, with all translation slots cleared, towhich address will host 10.0.0.101 be translated when initiating a session to webserver 172.16.0.5 on...

HiI have 2 Cisco Catalyst 6509 switches connected directly using direct point to point link.The OSPF is configured for point - point link.The currently the interface is down administratively.I will unshut the port . After that i would like to know ho...

Hi AllI was wondering if anyone can shine some light on a natting problem I am having.We recently aqquired a new outisde link and was assigned a block of IP addresses.Point-to-point IP:   66.8.29.242/30Point default route to  66.8.29.241/30Allocated ...

Hi Experts,I need your expert advice for BGP network advertisement at ISP.Recently we have migrated our Domain from India Data Centre to Singapore Data Centre. My branch offices located at New Zealand / Australia facing slow response issue after migr...

Hi,I would like to monitor the "environment" of my ASR 1000 Routers. Can someone tell me how to enable SNMP traps for especially power supply faults?Thanks,Dirk Kleinert                  

Hi,I've a scenario where I need to redistribute between EIGRP and OSPF. We have choosen Static redistribution between protocols ie.,Static to EIGRp and static to OSPF. I'm attaching picture of the topology. From R1 and R2, static routes for 10.33.0.0...

Dears ,             Counter Input Bytes are cleared automatically on my router interface . the router wasnt restarted and traffic is flowing properly .Please advise Regards

Dear folks,I am currently trying to deeply understand Weighted fair queuing (WFQ), how exactly it schedules packets for the outgoing hardware queue.As far as I understand, the queueing in each queue is done in such way:Packet enters the queue corresp...

Hi all,Can someone explain me the output of the command "monitor platform software process RP/FP active" on ASR 10001 (15.1(3)s2) ?I don't understand why the sum of processes %CPU never equal to total %us and how can i troubleshoot the %sy processes ...