Routing

Dear Team,When router is in ROMMON mode, we will be getting a diffrent mode as rommon1>, rommon2>, 3,4 etc. so is there any significance for these indivisual rommon modes or all the modes are same. PLease clarify.Thanks in advance,Naveen

HI,Our branch office is connected to head office via 2 links from 2 different service provider. Traffic is routed through BGP via 1st service provider and traffic is routed through EIGRP (Tunnel) through 2nd service provider. 1st link is of 512 kb an...

Hi I have a SG500-28-K9-G5 at work and I'm tyring to connect to it trough the console port via Putty and get wierd symbols:When I press any button I see alot of wierd symbols comming up, for example if I press shift+6 or Enter (or anything).Image:htt...

Hello guys.How can i verify end-toend connectivity for two x.25 routers ? is there a ping command for x.25 ?  or what commands can i use on a cisco router to see if it can reach a remote  x.25 router.  thanks

Hello there.i am troubleshooting an x25 connectivity problem, and i need to know the meaning of the numbers in the "match/use" colum of the output of the " show x25 route " command. See attached imageregards.

Hello everyone!We have software router vyatta and about 15 branches with cisco 881w and cisco 1941. All branches have 10mb\s bandwidth and 3 of them have 50mb\s. Link to vyatta has 100mb\s bandwidth and situated in datacenter.All branches connect to ...

Hi AllI' ve come across an weird  ospf issue between my router connected via layer 2  service provider link, details as below Overview : We have a base station router for satelite termination at service provider end connected via Layer 2 vlan link to...

I'm needing to create a QoS policy on a DS3 connection at a hub site.  There is a DR site with a DS3 and then several remote locations connected via MPLS.  I wan to limit the bandwidth that each remote site can use (close to their max limit) and appl...

Hi,I am having a problem with a Cisco 887M-K9 which keep dropping it sync.I have tried 2 diffrent locations and both time it dropped sync after 15 or minutes where other routers are working fine.Please find below my config as well as the logs when th...

Hello Everyone!I have a 2Mbps link where I need tom confgure a QoS... I already have a QoS configured over there but my Netflow tool shows me a different scenario preety much different from my QoS CLI ConfigThis is my config belowpolicy-map qos_new c...

             Dear All,i have confusing between E2 and E1, as showing in the network diagram, if i redistribute the loop back under ospf as following:router ospf 100redistribute connected subnetwhen i do show ip route on R3 for any loop back subnet (s...

I am trying to configure traffic-shaping on an interface output but the command is not in the CLI? I used the feature search and the platform model along with IOS is supported for Generic Traffic Shaping. Is there a pre-requisite on enabling this fea...

Have two asa's and two isp's.  does cisco have another dual isp failover solution for the asa except bgp.  Have a number of servers behind the asa and alot of inbound translations to those servers.  Would rather not re-ip those and have to get a clas...