Routing

Hi,I have a SP that is requesting the following and I wanted to see if I can get your feedback.Customer requested a 2 circuit T1 with Internet, as a new requirement the custemer requested to configure  tunnels for INTRANET communication and the recom...

Hi,I have cisco 3845 router with 4 HWIC-2FE card none of them is detected the message displayed is Oct 4 11:21:35.323: %ESWMRVL_FLTMG-5-NOTICE: Notice: FPGA Rev 0x27 *Oct 4 11:21:35.323: fe_mrvl_hw_init : Could not load driver*Oct 4 11:21:35.323:...

Hello All,I am attempting to downgrade the code in a new ASR 1004 in order to satisfy the company's software code requirements.The router is an ASR 1004 and is running this version of software:            asr1000rp1-advipservicesk9.03.06.00.S.152-2.S...

Hi All,     So I was curious if someone has a rule of thumb for DMVPN hub router sizing.  Something on the order of if you have x remote sites you need at least an 1800/1900 for your hub router, or at y number of sites you need to step up to a 2800/2...

Currently all of our sites are connected through the mpls, as shown in the first network diagram. We just got fiber put in between SiteA and SiteB. What I need to do is disconnect SiteB from the MPLS, connect B to A through the fiber line as shown in...

Dear Friends,I have three STM1s between a PE & P Router.All the parameters are the same of these links. Even the OSPF cost is same, but one of the STM1 link is carrying much higher traffic than others.As a normal behavior all three links should load ...

Hi,The 3G card that I've been deploying for some remote users, using the 881 that live in remote areas have an esn number for Verizon. Can I order a card that would be used with AT&T?Thanks, Pat

Hi ExpertsI Have asr 1004  , i have enabled the CDP globally and per interface level, but i didn't see any Cisco neighbor device despite the orther end already has CDP is enablethanksjamil

Hello Guys,I want  to setup qos rate-limiting.  i want to allocate 50% of my internet link bandwidth to PRIORITY-QUEUE, and 50% of bandwidth for other web-traffic and default-traffic.My question is :  while i configure and alocate 50% of bandwidth fo...

I have a single router at location X with two circuits, one is MPLS from this location to DataCenter.Another is internet circuit.Traffic for DataCenter is going Via MPLS circuit.And internet traffic is going through Tunnel3.Internet traffic goes thro...

Hi everybody.I have a cisco 1841 router which isn't able to boot properly from its IOS. it always prompt me on ROMMN.Here it is: System Bootstrap, Version 12.4(13r)T8, RELEASE SOFTWARE (fc1)Technical Support: http://www.cisco.com/techsupportCopyright...

Hi every expert,It's a problem about access ASA5500 Firewall mangement port. The customer request access ASA5500 by entering the default IP address https://192.168.1.1 to monitor data tracffic in Windows 7. But after entering the default IP in IE, no...