Routing

Hello,I have an issue I would like to seek help with. I have 2 ISPs terminating on 2 FE ports on my 2811 router.ISP1 had always been here, used for the following:Internet access to LAN usersInternet access with public IP mapping to servers in differe...

I have configured a 4510 switch for a customer and they are wanting me to connect it to their wan router. They are asking me to setup OSPF on the 4500 advertising a few of the networks. Internet bound traffic will also have to traverse the wan router...

dear friends,sorry if this has been discussed.. but i am not able to understand so i am giving my shot to understand this concept ..we have a bandwidth pipe terminating on 1841 BVI interface... now we want to limit all the traffic going from inside t...

I wish to apply QoS to a router with a DSL line. One the LAN side, there is data being uploaded almost all the time, but it's not very important, and it's saturaing the DSL line (all of it's mighty 800Kbps upload).I wish to make this data stream of a...

Hi all while executing Show int command on one of our remote site , seems Data Set Ready and Clear To Send are on down state , as shown below.......Serial0/1/0 is up, line protocol is up  Hardware is GT96K Serial  Backup interface Dialer1, failure de...

Hello,could somebody please explain what does router#sh policy-map int GigabitEthernet0/0.15 out GigabitEthernet0/0.15   Service-policy output: policy1...         Class-map: Class-map1 (match-any)           36699 packets, 5431222 bytes           30 s...

hiI have the Cisco 3800, C3845-IPBASE-M), Version 12.4(24)T2, RELEASE), I am trying to create the int vlan, in global configuration command, but it does not give me the optioncan you please suggest what can be the problem?below is the print of sh ver...

I am a Cisco Noob.That said, I am having trouble setting up my new 1921.  Also, I'd like to note that I am setting it up for an office that I do not work in, so I cannot verify if the routing is working when I change it.  I kind of need a bulletproof...

Hi allWe have an issue on a site where our Video conference equipment betwen 2 sites keeps cutting off. There is a 4Mbit MPLS conenction between the 2 sites.The VC equipment was put in the priority queue and given 1.5Mbits, even though it connects at...

Running into an issue upgrading a ASR9000.  There is not enough space on Disk0: to upload the new image.  My question is are the directories able to be deleted to make space for the new image?Can anything with the 4.2.0 be deleted before the upgrade?...

Hi,in close future i'll have to transition Frame Relay to L3VPN WAN links. I have two available routers and my dilemma is next:1) i can connect my ISP's optical link directly to my primary router - in that case i can use simple hot standby (backup) r...

I've got a 2600 that I am wanting to connect to my cable modem. However I don't have the knowledge to get it running. My ISP uses a dynamic IP and I am unable to get it to connect.ROUTER#show runBuilding configuration...Current configuration : 685 by...