Routing

I have a backup router scenario for my remote sites I'm trying to build and test.  The remote site router has an IPsec tunnel to an ASA 5510 facilitated via crypto map applied to a fastethernet interface which is attched directly to a DSL modem and g...

Just a scenariorouter 1 and router 2 (isp)router 1 wan ip --101.2.2.1router2(isp) wan ip-  101.2.2.2I have network of 202.x.x.x/24on router1neighbour 101.2.2.2 route-map chic in route-map chic permit 10match ip address prefix-list dafaultset local-pr...

Hi,In general we have installed an analog cameras in many of our branches and remote sites and we want to isolate the business applications traffic from the cameras viewing traffic as the follows:HQ Links:- main link: by default all the branch traffi...

hi all, My requirment is to drop the Internet traffic once the Cisco HWIC 3G backup link will become active(attached) .Because I should allow only Business Critical Data allow through that and others should drop. Here are the config I used. In here I...

Hello,I have 2 ASR 1006 with ASR-1000-ESP40, ASR-1000-SIP40, ASR-1000-RP2 , and with SPA-1X10GE-L-V2 that should hold an XFP-10G-MM-SR.i am in the proceed of an implementation and configuration, but i am facing a problem on the interfaces, where i am...

HelloI have a strange issue I have encountered.I have a ISP connection going via Cisco Router to a remote network; it has a Riverbed in line both on local as well as the remote site. The issue I am facing is that the ISP connection is allowing Apple ...

Hello, all, we just bought a 2921 with the following modules:4 port clear channel T1/E1 HWICSM-ES3G-24-P: EtherSwitch I read some CISCO documents, and not be able to find what I need. I would prefer all instructions from you are for CLI interface.Thi...

We have a new remote office deployment.It's going to have 15  to 20 users. Cisco 7965s that will register to the Main site call Managers. A 3500 access point that will also register with a controller at the Main site. We are going to order a 50mb dow...

We copy large amounts of data from a host in site C to a host at subnet 10.234.0.0/22.  I have two paths to get from C to the host.  One is perfered by us due to larger bandwidth.  The link between C -B is a gig and B-A is a Gig.  The link between C-...

As per as scenario router 2 and router 4 are the routers which are located in my comapny.Router 2 is active router and router 4 is the standy router.Router 0 and router 5 are isp routerMy requirement is that the packet which are going out ofmy  netwo...

Hi,I typically only configure ASA5505s or RV042s, but I currently have to fix an issue with a Cisco 877.When it tries to connect I get. "Di1: No free dialer - starting fast idle timer"Here is the current config: (Changes made only to protect security...

                   I'm building a CCIE lab and wanted to know does it matter what 3560 switch I use. I see some 8 port ones going for a good price but I just wanted to know if if matters what model 3560 switch is used? Thank