Routing

please see the below log file of cisco switch and suggest me what i can i do for that situation:----------------------------------------------------------------------------------------------------------------------------------------------------------...

we have two sites that are primarily connected to an MPLS Provider.  Each site has an 1841.  Site A is connected to the MPLS provider on a VWIC-2MFT-T1Site B is connected to the MPLS provider on a VWIC2-1MFT-T1/E1The two sites are also connected toge...

HiMy question is about the difference between FIB and CEF Table. Are they two different tables or same table that has two different names?If they are different tables, is CEF Table created only when MPLS is enabled?Thanks..

Hi We are facing output queue problems on our ATM interfaces. A lot of output queue errors are been shown as below. Need help in solving this issue.Cisco 2811 -> ATM Link -> <-ATM Link <- Cisco 3945 Routers.Cisco 2811 Version is 124-15.T9.binCisco 39...

We have a problem with our WS-C3560V2-24TS running IOS c3560-ipservicesk9-mz.122-53.SE2.bin.The equipment keep dropping packets for no apperent reason.This is what we are seeing:LAN-portRouter0#sh interfaces fastEthernet 0/2 | include drops:  Input q...

Good morning,I have an 881G 3G router.  We use this on an as-needed basis at different branch locations when an ISP has an extended outage.Question is, is there a 4G card for the 881G, or do we have to get a different model router?...if different mod...

I am troubleshooting some issues with an EIGRP based network that is experiencing intermittent outages.  The attached file is the "show ip eigrp traffic" output from a few of the routers.   The SIA queries and replies concern me but I am not sure on ...

i have doubt regarding STP , in listening state and learning state ,of stp port sates why its needed to introduce a delay of default of 15 seconds before moving to forewarding state . please let me know what ths use of it

Hi All,Does the Network Module "C3KX-NM-1G" and "C3KX-NM-10G" for Cisco Catalyst Switch 3750X Comes with a transciever like GLC-SX-MM or SFP-10G-SR or do I need to order in seperately.Thanks in advance..--Shameem

Hi,We have some concerns regarding MEM-2900-512U2.5GB=.Firstly, I would like to know this part is essential to run router. We will enable BGP which has 11833 prefix only.Not running others such as Security, IPSEC.what is the main purpose of this memo...