Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Labels

Forum Posts

Hi allIf I make changes to network statements, ie what networks my BGP router in HQ advertises out, would this cause an outage or make the BGP neighbours go down ? surely its ok add new networks without impacting the system?also when adding a network...

Where is it documented on best practices on where to put RRs? Suppose I have:                   The RR will advertise to the 2 below. But because ebgp learned routes are advertised to ibgp neighbors, what rules dictate if R2 is NOT the RR and R4 coul...

Hi everyone,I am looking for a way to use a 3G connexion on ASR1000.Is it possible to install HWIC module of ISR2 in SPA slot or use an USB modem on the RP?Thanks in advance for your reply.

Hi, I'm trying to setup HSRP on two C877 routers. Fo some reason advertisements / helo packets are not going from one router to the other. I have Cisco switch (C2960) in between and I was wondering If I need to set up something on this switch?My conf...

Hi allCan anyone tell me at a basic level how BGP selects its pathIf I have currently an MPLS running bgp to my provider, they then want to put in a new circuit, which would be same BGP/VRF i should imagine, if this is new circuit connects to the sam...

Hi,I have a vsat connection with 2 E1's in a multilink. Does it matter that they are showing different clock sources.?one is showing as Internal and the other is showing as Line.

I think that my rommon image has become corrupt as it will not take a new IOS image. I have tried several images that are within the recommended size and work with another 2620 with exactly the same specificationalso some commands that are available ...

Currently I'm looking for a way to failover our internet connection from one site to another site over our MPLS line, should that internet connection go down.My layout: Internet > Cable internet modem (Site B) > ASA 5510 (Site B) > 2821 Router (Site ...

Hi!In the Cisco IPS Threat Defense Bulletin 6-21-2012, there is listed a problem with IOS Release 15.0(1)M8 and the issue described in the caveat CSCtz27137:IOS IPS Important NoticeIOS IPS customers running version 12.4T, 15.0M, or 15.1M - a critical...

hi , i would like to ask a question when using point -point wan network ,now im using subinterfaces for point-point , my question is  ............... when using point-point , should i make a static mapping ??i mean that if i uses point-point  and typ...

Dr.X by Level 2
  • 947 Views
  • 3 replies
  • 0 Helpful votes