Routing

Hi,We have recently upgraded our lan network over different sites with cisco routers and switches and icorporated VOIP in it.There are actually sevent sites with EFM internet service.Cisco routers that we use are Cisco 3725 at headquarter and Cisco 1...

Hi,I try to configure a Cisco 3925 with VWIC3-1MFT-G703 for an E1 but the line is still downform my side and from the site of the provider the config below:!controller E1 1/0   channel-group 0 unframed!interface Serial1/0:0   ip address XXXX XXXXWhen...

Hi Guys,Can the ASR1004 RP-1 act like a switch? where i can create SVI,vlans, and switchport mode trunk or access on a particular ethernet interface?i tried to create an SVI but it failed. the IOS-XE im using is "asr1000rp1-adventerprisek9.03.05.00.S...

I am trying to research what Cisco equipment can handle 10 1 gig ports comming into it.... I have heard that some of the Cisco equipment just simply can not handle this capacity.... Is there anyone out there with some real world experience and willin...

Hello to all,I would like to mention that I am a total new comer (NOOB) for Cisco Router. All I know is plug the console cable to a serial port on a PC, fire-up HyperTerminal to view and that's it. I don't know any command or scripts.I am trying to l...

Hi,Please check attached rough diagram.I'm not advertizing 151.41.1.4 anywhere to B,C,D. only router A knows about 151.41.1.4.can I put following static route on D:ip route 151.41.1.4 255.255.255.255 192.168.1.1will above "static route" send all traf...

Hi everybody, I have one problem doing a ping to a router lan interface, I have 3 routers (2801) connected between each other (separated 1 mile each), the link is established trough microwave signals (connected to the 2801 fast ethernet interfaces), ...

Here is my home topology:1. Dell Server: Domain: SWLAB.lab, Static Ip 192.168.1.91/24, Default Gateway: 192.168.1.1/24, Running services DHCP and DNS. DCHP ip scope 192.168.1.1 - 192.168.1.100. Ip address excluded start ip add .1 end ip add .5, .50 -...

Hi, in Cisco 3945 product sheet its written "3 integrated 10/100/1000 Ethernet ports with 2 ports capable of  RJ-45 or SFP connectivity "Does that mean i can use 3 Gigabit Interface for sure , without buying any additional SFP cards?and if i buy 2 SF...

Hi All,I need some advice. I'm looking for a Cisco device to run a full BGP table with a 60Mb link. And one of the main restrictions is that my traffic is almost 100% real-time (voip). So the average packet size is small. Today we own a Cisco 7204 NP...

we have a nam module on a 7613. I have access to the router. but how can i know the how to access the nam?thanks,

I have a weird BGP issue.The issue is I see in the routing tables and BGP table the route and where it should be routing to from other locations, however, when I run a traceroute it does not go the direction I intend it to go every time.  All output ...