Routing

Hi,I am having issue with a RV082 with firmware:v4.1.0.02-tm (Sep 16 2011 18:40:48)On setup 1 I have;Using 2 WAN, 1 from fiber 5mbps symetric fixed public IP and other is DSL private dynamic dhcp address 3mbps/900kbpsOn setup 2 i have:Using 1 WAN, fr...

I'm trying to replace a ASA 5505 with a Cisco 2801 w/ security bundle.I have gone through a pretty basic set up of configuring what I could and letting the Cisco Config Prof do the security audit to lock it down. I have everything working just fine e...

Hi all,I have a 3845 router connected to 1841 router through ethernet. both routers are connected through on board ports(G0/0 of 3845 to fa0/0 of 1841). In general both the ports are working fine. Due to some requiremet I want to increase the payload...

Hi, I am configuring Internet border routers for a company doing ecommerce business. I want to prefer/deprefer certain paths in a mulit-provider uplink scenario (2 routers / 2 ISP's). To do that, I have chosen to prepend local AS 1-4 times based on d...

Hi,I have a SDH link with a G703 interface and I was wondering if the VWIC2-1MFT-G703 card would be the right card in this case?Any help is much appreciated.

Hi,I'm troubleshooting a connection problem with a CISCO1812/K9. I've narrowed it down to being a PPP CHAP authentication problem.Here is the debug that shows the PPP athentication messages:MYROUTER#debug ppp authentication*Dec 22 20:27:55.198: BR0:1...

Hello,I have one public IP address but multiple local servers that run on the same port. I cannot change the port the clients use to connect to this server, so I can't do a port map in my NAT router. The solution I had in mind, is to filter on source...

I want to purchase CISCO2901-SEC/K9Please let me know all its specification and how many Ethernet ports supported by its modules?Thanks

HiI`m connecting a client directly to a 3750, and giving them a public IP.On the port I have set spanning-tree bpduguard enableBut I guess I shold also set some storm control etc.What settings shuld I use for storm control?The client has a 100Mbps in...

Deploying a network with ASA having 2 Public Ranges and 1 Private Range.The Public range is xx.xx.xx.ab\29& xx.xx.xx.cd\28On ASA interface 0/0 i have assigned IP \29& on the inside interface I have assigned 192.168.209.4\24Now would i be able to use ...

I have rotuer 3825  172.16.11.1 connect with 1811  172.16.11.200. I did sh ip route. here is result.   10.0.1.0/24 [110/2] via 172.16.11.1, 00:27:26, FastEthernet1    10.1.1.0/24 [110/3] via 172.16.11.1, 00:27:26, FastEthernet1    10.2.1.0/24 [110/4]...