Routing

hi,following BGP config -interface GigabitEthernet0/0 description ****Last Mile1 ABCDL**** ip address xx.xx.xx.30 255.255.255.252 duplex full speed 100 !!interface GigabitEthernet0/1 description ****Last Mile2 EFRGH**** ip address xx.xx.xx.34 255.255...

Hi Guys,Not sure if this is in the right place.I have just taken delivery of 6 new 2911 routers, I have just started to configure them using IPSEC tunnels but found that the licence installed does not provide this feature. I have enabled the "Securit...

Hello guys,I have a 7604 Edge router that connects to our Data centre via Fiber.but i keep getting input errors on the interface Gi3/5.  i also found out that i cannot change the duplex settings on the edge router to auto, i only have two options of ...

hi allI have problem with ASR 1002-F and mudule SFP-GE-T.ASR(SFP-GE-T)-G0/0/0---------------------------------G0/1-SW29600But when configure ip address for G0/0/0 and see that the protocol and status can't up but the status on SW2960 G0/0 is up I don...

I am trying to figure out why the following hardware config will not work, I must be missing something obvious?  I have my LAN, 192.168.1.0 , plugged into my Cat 2960, I want to also plug my the WAN interface of my IPSs router, 212.xxx.xxx.25 (my def...

Hi,I installed a new SA540 and configured some NAT rules for my Exchange server. Everything worked fine untill I did a firmware upgrade.Now the NAT rules won't work on my dedicated WAN.On the Optional WAN (load balancing) the NAT rules work fine. Wha...

Hi, we have 881 routers and are planning on testing out some WAN optimizing hardware, we're told that our router needs to support PBR and WCCP protocols.  Will this router handle it?Brian

Client has an ASA5505 anchoring an MPLS network. One of their branch offices is experiencing frequent circuit outages due to theft of copper lines. I am looking at an 881G with wireless aircard as a backup solution and creating a VPN tunnel to the AS...

hi i have 2 x T1 terminating on border router cisco 3640 route. (configured using multilink interface). Our IP block is routed on this bundled T1 circuits by At&T. I want more internet bandwidth.1.  Can i connect my DSL (on ethernet interface and usi...

Hi GuysDuring adding and removing of BGP peers this Log message was reported.Oct 17 00:56:37.469 BST: %COMMON_FIB-DFC2-4-FIBIDB: No fibidb found for if_number 32 during path long ext decode for 197.238.0.0/16 in IPv4:Default I have searched long and ...

I recently bought a new Cisco WRVS4400N router for our network which has 19 computers connected to a 24 port switch.  We are currently using a D-Link router and are upgrading to the Cisco router.  The problem I am having is as soon as I connect one o...

Can someone give me the reasoning why the above module cannot support E1 ATM?  And is there any other module which can support both E3 and E1 at the same time?