Buy or Renew
Buy or Renew

Routing

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation

Labels

Forum Posts

Start a conversation

MWR2941 CEM QoS

I have a question regarding enforcing a QoS on Pseudowire packets coming from a T1/CEM interface on an MWR2941. I have the TDM pseudowire working great testing in a lab with two T1 testsets. The problem is prioritizing the T1 traffic so that on small...

Resolved! GRE and static NAT problem

Hi I have problem with the following setup:I am using DMVPN (GRE, IPSec and EIGRP) in my network, tunnel interfaces on both routers are in the same subnet 10.64.24.0/22. Tunnels are up and functional. On R2 I have static NAT configured:ip nat inside ...

WCCP in and out simultaneously

Hi All,Is it ok to define WCCP in both directions on the serial (WAN) interface using two different WCCP service groups? The NAT is performed on the router. We would like to have client source ip in the NAT table instead of the WAE as inside address....

PJ by • Level 1
  • 431 Views
  • 1 replies
  • 0 Helpful votes

Resolved! iBGP peers not communicating

I've got a bit of an odd BGP problem that I'm hoping someone might be able to advise on. I've attached a basic diagram to make it easier to describe the problem.Router A has a BGP session to ISP ARouter B has a BGP session to ISP BAll three routers h...

DC-DR scenerio as active/backup?

Hi .I have my DC built up and i am going to built DR in two differentgeographical locations.I am planning to use DC as active and DR in case offailover.In DC I am using a public IP pool x.x.x.x and running BGPover there with the ISP. I had hosted my ...

mandeepku by • Level 1
  • 955 Views
  • 3 replies
  • 0 Helpful votes

Resolved! Show isdn history (NOT SHOWING CALL HISTORY)

Hi all,I am trying to see if my ISDN (backup) circuit has been active recently. I have tried this command:>#show isdn historyoutput:---------------------------------------------------------------------------------------------------------------       ...

L2TPv3 vs DLSW for Bridging VLANs

I'm currently using DLSW to bridge a VLAN to a remote site and it works fine.  I've been reading up on L2TPv3 and now I'm wondering if one is better than the other for my purposes (my hardware will support both), especially if multiple VLANS are bein...

static routes and BGP

guys suppose i have two routers a and b  A is connected to ISP and thus using BGP.........A is getting a route of 10.1.1.0/24 from B.....and we have added a static route towards B for 10.1.1.0/24 network (towards B ethernet, A and B isconected via et...

Load more