Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Hello,I have two 881 Routers with IOS 15.1 on it.I build a VPN Tunnel between them to connect two private NetworksNET "A" 192.168.114.0/24 <> Cisco 881 IPSEC "A" <> Public Network <> Cisco 881 IPSEC "B" <> 192.168.115.0/24 NET "B"Everything works fin...

tnt by Level 1
  • 1963 Views
  • 6 replies
  • 0 Helpful votes

I've seen this question around but never a definitive answer. It seems people get confused about what the required outcome is so I'll try and be detailed. We have W2K3 domain with Catalyst 4507 routers.Client (laptop, tablet etc) needs to redirect we...

Dear all,What is the load balance method of 3750 port channel ( by source ip , or by source mac ) to diver traffic to paths?I have tried to use 10.242.104.101 and 10.242.104.102 as source ip, it will travel to the same link (G0/1) within one port cha...

acbennyma by Level 1
  • 3541 Views
  • 1 replies
  • 0 Helpful votes

Hi All,I need your confirmation on this set-up that i'll be attaching. I am planning to implement this set-up, ECMP from the Core to the Internet Edge with ASA. From the edge default route will be injected pointing to the Internet and route redistrib...

Network is growing.I need a tool for SNMP provisioning.A control panel where I can enable, disable services on switches etc.For example set rate limit, ACL and so on for customer ports.I have mostly Cisco, but also Procurve and Zyxel (enterprice).I w...

perpaal by Level 1
  • 461 Views
  • 1 replies
  • 0 Helpful votes

hello all,i just managed to config the Cisco 877 and send it to my client,when the client connect the router from his location the router can't make VPN connection to my HQ office,i can connect to the router using the external IP adress,i tried to re...

Dear Team, We have 3750 and 4510 switches and in both we run Q-n-Q but we observed looping/Broadcase Storm we already run STP on 3750 end and this is corporate branch but 4510 its difference branch where we run q-n-q technopoligy please let me know w...

I recently installed a WIC 1DSU-T1-V2 card into a 1841 router to add to a multilink bundle.  I inserted it in Slot 1 and powered up the router and there was a new serial interface showing in the config automatically as s0/1/0.  I was able to get it s...

qbakies11 by Level 1
  • 1405 Views
  • 1 replies
  • 0 Helpful votes

Hello,I will now try to ask here I have some problems with stability of my OSPF session between 3 devices. the topology is simple:cisco7200 --- catalyst3560 --- cisco2600the cisco7200 and catalyst3560 are speaking MTU 1546 (because of QinQ and MPLS)c...

Unanswered Topics