Routing

Is buying 2 WS-C3550-24-EMI enough for the ccnp switch 642-813 (+GNS3)???????? (real switches can be connected to GNS3 right ?)Or one should buy different switches,and where to get the best prices and available shipments to Beirut, Lebanon??

Hi All,       I am using a 2811 Router with NM-16ESW Swith Module in a branch, OSPF is the routing protocol Switch Module's Fa0/1 is used as Primary connection (with cost 1) and Router's Fa0/0 is used as backup connection (with cost 100).Do I need to...

Hello,We have a Cisco 886 configured with two WAN's (ATM0 connected to a DSL line and Fa3 connected to a CMTS modem).We're running  DMVPN over the Cable network and GetVPN over the DSL line. When the DSL line is down we see a lot of CPU peaks up to 9...

Hi guys,i cannot seem to apply QOS on version 12.4 (15) on a SVI it get a configuration failed.i need to apply shaping on this interface but i cannot get to do it, i need help.thanks

Hello,I just started configuring my cisco catalyst 2950 switch. Basically im preparing for my CCENT exams my basic configuration is as follows.My Laptop is connected to the console portI'm connected to the internet via my wirelessI'm connected to the...

Dear All,We configured 1941 k9 router for inernet purposeip name-server 218.248.255.146ip name-server 218.248.255.212multilink bundle-name authenticated!!!license udi pid CISCO1941/K9 sn FHK144773MG!!interface GigabitEthernet0/0 ip address x.x.x.x 25...

Hi, i have a user in LAN which needs access to remote PPTP server. My router uses NAT NVI for some reasons to provide internet access.Problem is what tcp/1723 is NATed successfully and it appears what GRE traffic is NATed as well, but GRE packets are...

Hello everyone,Can somebody tell me if RV082 can establish PPTP VPN connection as CLIENT? (i'm aware it can provide function of VPN PPTP server but could not find if it can act as client).To explain further: I'm based in Europe and use US VPN to acce...

Hello.Can somebody tell me why the ace is not balancing the load equally or almost equally through the all 3 servers?3 servers^||ACE^|SW^||USERSThe following commands shows that the server SP2 is  having the most of the connections to it.ACE-DIGENERA...

We get these alerts every day and we can't figure out what they really mean.  Any assistance would be greatly appreciated.Thank you in advance,IT Group, NaviNet, Inc.OneSight Warning Alert(12/14/10 2:00:31 AM EST) Trap Received:Enterprise: .iso.org.d...