Routing

Hi, i have a router 7206VXR, and it has 128 mbytes of ram memory.How many memory i could put to this router? , and what is the part number?.

When I am booting a router 3620, I am unable to detect flash memory.what would be the reason. Is Flash memory becomes unserviceable.And what about IOS.Is it available in the market, if yes what would be the cost.

Hello, does Cisco make a router that can handle a 20,000 line ACL?

I have a router with the following 2 interfaces:interface Vlan1 description "192_Network" ip address 192.168.1.253 255.255.255.0 ip nat inside ip virtual-reassemblyinterface FastEthernet4 description "172_Network" ip address 172.16.1.253 255.255.255....

I need to filter networks from being received over eigrp.Site A is advertising10.80.20.0/2410.80.24.0/2410.80.16.0/2410.80.50.0/2410.80.91.0/24I want to prevent Site B from receiving all route except for 10.80.20.0/24.What is the best way to do this?...

I'm running an MPLS network with BGP. I have three data centers with an Internet exit point in each 1. Site A (GA) 2. Site B (TX) 3. Site C (AZ).The result I am looking for is to have east offices use Site A (GA) for outbound Internet and west office...

I have a LAN (10.1.100.x), WAN (outside), and a DMZ (10.1.10.x) running off a ASA 5510.Rather than using NAT, how can I bind static IP's directly to devices on the DMZ (exposing them on the Internet, thereby) instead of using NAT to the 10.1.10.x hos...

We are installing a redundant internet connection and I would like some input on design consideration.  In the the attached image, the Internet 1 side is already in place.  We are in the process of getting the second 100MB Ethernet connection in plac...

Hi,What is the benefit of (HWIC-4ESW) module, I see it used more in CCVP Lab, is that mean I can use it instated of SWITCH.