Routing

The latest 12.4 IOS for the 7206-VXR and 3845 routers supportsBFD (bidirectional forwarding detection) but only with OSPF.We'd like to use BFD in our environment, but we're an EIGRP shop withno intention of switching to OSPF.Any Cisco engineers here ...

Hi, this comes from our facebook community.  http://www.facebook.com/CiscoSupportCommunityI'm  lost in Static Routing. Can anybody give me the sequence, actual code  (using ip route) and instructions on how to do this in packet tracer?  ---I have 4 r...

Hi,We received this question on our CSC Facebook community.  http://www.facebook.com/CiscoSupportCommunityI  have a question on IRB.  I have a 2821 router doing bridge groups.  Is  there a way to make set the protocol to RSTP?  I tried to do it, but ...

Hi,This question comes from our CSC facebook community.http://www.facebook.com/CiscoSupportCommunityAhmed Shaheen greetings everyone, simply; if my WAN is advertised on OSPF 1 and my LAN is advertised on OSPF 2.why can't OSPF 2 come up!all settings a...

Hello,I have c2611 configured as basic router with two interfaces (1 on internal and 1 on external network). No NAT, ACL neither than Firewall configured on interfaces. Something like:PC(ext) <-HUB-> (ext)-router-(int) <-HUB-> PC(int)I'm able to ping...

Hi:We are going round and round with Cogent on this ping health check issue. Our ACL's have been in place for some time. Recently we had a link failure and when the T-1 returned to service, Cogent claimed they could not ping the WAN serial interface ...

Hi Community,Is is possible to create VLAN's on a Cisco Router 857.Thanks for the help

Hello.I am choosing Cisco to connect my wireless network to the Internet via ADSL.My ISP uses PPP over Ethernet  with SNAP support.And modulation is ADSL 2+ ( ANSI T 1.413. i 2).My ADSL works over POTS and shares line with my regular phone.I do not r...

Hi All,Hope someone can help me out here. Need to get a design complete and i need some ideasThe basic topology - Two Sites - 2 Cisco 3560Xs at each site. Each pair of switches is trunkedusing etherchannel. I've got 2X 1GigE links between each site, ...

Hi guysI have configured a multiple static NAT  for a firewall (10.100.1.2) using ip nat inside source static on a 2600 router with one ethernet interface as inside and two ethernet interfaces and a serial interface as outside, using the following c...

Hi,I need to span a vlan 100 across 2 sites connected via ethernet. I am thing about using BVI.Both sites are sharing different VLANs. How I can use BVI for this solution and not brake other connection for other VLANs ?New vlan is 200 Old VLANs :  vl...