Buy or Renew
Buy or Renew

Routing

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
Labels

Forum Posts

Start a conversation

Resolved! Basic MED:Why MED is not being set correctly?

Hi, this is a very simple configuration. My intention is to set MED on R1 and later make that as my preferred traffic traffic entry point.I see on R1 'show ip bgp' that incoming traffic is correctly identified as AS '200'.However MED is not being set...

news2010a by • Level 3
  • 783 Views
  • 6 replies
  • 0 Helpful votes

Resolved! Can't stop double NAT

I have a new client that is having trouble with their network setup.  They were running with a 1721 router as their only device connecting them to the Internet and things worked fine.  They decided they needed a firewall so bought a sonicwall and put...

qbakies11 by • Level 1
  • 3667 Views
  • 3 replies
  • 0 Helpful votes

ip sla - requiring two failed tests

I would like to require ip sla (here http get test) to fail two tests in a row before being considered "down" (and triggering a route change). Is it possible to do this with IP SLA? I'm on 12.4 IOS. Thank-you.-------current ip sla config------trac...

mmedwid by • Level 3
  • 1042 Views
  • 5 replies
  • 0 Helpful votes

terminal monitor

*hello i am getting the error message ho can i know the end point device BDCHSS10my side is: fe0/1 Mar  2 12:56:08.663: %CDP-4-DUPLEX_MISMATCH: duplex mismatch discovered on FastEthernet0/1 (not half duplex), with BDCHSS10 FastEthernet1/0/19 (half du...

RPSAN VLAN

Hi,we have 6500 and 4000 switches connected each other trunk, all vlans allowed on that connection.  We are using rspan from various source ports and on both 6500 and 4000 there is one destionation.source remote vlan 800destination interface g1/1When...

Resolved! Bandwidth Problem

Dear all, i m having two links one is Multilink(4Mbps)& Pos-Stm(155Mbps)i get the following output , but when i made Multilink up,  * 172.26.44.38is replaced with  10.72.1.218(MultiLinkIp)whatz the command i can give so that default it will go throug...

Multicast

1. On a mcast router that is failing RPF test, from source 10.0.0.0/24, is it safe to define an mcast default route like thisip mroute 0.0.0.0 0.0.0.0 172.16.0.1 instead of the subnet routeip mroute 10.0.0.0 255.0.0.0.0 172.16.0.12.How do I know when...

TCP to X.25 Translation

Hi,  Request for help on the configuration to convert an IP traffic to x.25 host.I am using the following router config with the error logs below. Connection failed without any reason. Anyone has done this could share tips with me on how to get it ri...

Load more