Routing

Hello,As I can configure following:I have two peers bgp, a peer sent me full table and other only default route 0.0.0.0/0 with a priority lowest that the other peer. If I want out traffic from as1000 by the secondary peer that is a default route, if ...

Here Bc & be both are 24000. Is it mean be is Zero ?interface Hssi0/0/0 description 45Mbps to R1 rate-limit input 20000000 24000 24000 conform-action transmit exceed-action drop

Hi,I have a issue for block the port 25 to all network from Yahoo. I knew all the ASN:I have two routers 7204vxr with three peers bgp and I want put a only filter.How can I configurate this filter?Thank You,Best Regards

Hi, I have 512kbs link. I have to implement qos. My CIR with ISP is 300Kbs & max burst allowed is 12 kbs in time of congestion. What would be my Be & Bc value. I am totally confused with Be value. Please help

how i can monitor the comunication tcp:- ack - seq- windows- finWith wireshark, and to do troubleshooting and to determine if i have any problem

Hi All,I have cisco 1801 router with 8 ports. I am trying to setup two different vlans on this equipment. fa 1 is connected to my LAN and Fa 2 is connected to my WAN.I want to have a vlan 1 used by Fa 0 and vlan 2 used by fa 2. Can you please check m...

Hello,Can you set up a frame relay circuit with a size of 386 with a WIC-1DSU-T1-V2? or does a frame relay circuit require a different card? It looks like I could use a WIC-1DSU-T1-V2 from what I have read. it is on a 2811 running IOS 12.4Thanks

Greetings, i need to configure and ship a router to Manila, would anyone be able to confirm the settings for a DSL circuit over there.I dont know yet whether it will be going to the metro or provincial area where i know the VCI and VPI are different,...

We have an extended ACL with "deny ip any any log" as the last entry. However, for repeated events like HSRP mutlicast, which we do not permit, we do NOT want to log the HSRP denies b/c we want to reduce our syslog messages. What is the syntax to "de...

Hi,here's the scenario ... downsized an office using a 3825 router with an ATM DS3 Network Module and replaced that with a 2811 using a different ATM DS3 module. Putting the original router back is not an option.Problem is that the ATM interface lose...

My primary link is up but still the 2ndary static crypoto route in my routing table.Crypto route not realeasing ver and platfrom detailsc7200p-advsecurityk9-mz.124-15.T6.binCan you help on this regds....

I have an issue with an Cisco 877w where is wont sync with the line card in a BT exchange. It goes into a repeating up / down cycle and has been doing this now for several days. I have tried multiple adsl firmware's but none have worked. does anyone ...

Dear all,I am seeing an intermittent 90% CPU load on a 7600 SUP720-3BXL / 12.2(18)SXF6.The above is traffic punted to CPU, which I spanned. it is mainly multicast traffic (with good ttl) but with a zero checksum.I also ran a netdr debug and got below...