Routing

Hi Guys, I already posted a case before 2 weeks describing what is happening with me regarding those VWIC2-2MFT-G703 cards I have and I am creating a new case now because I got another info that may help detecting this issue.I have this error message...

Hi All, I have a 2811 with a Network Module (NM-2CE1T1_PRI).I want to understand the configuration of my router (please see document attached). I understand this is a Network Module that has to E1 ports.There's one E1 that's configured but it is divi...

Hi Everybody,I need a clarification on the behaviour of BGP with equal cost path (maximum-paths 2)I have 1841 Router with Dual leased line named my ISP named ISP-1. I was runnning BGP between my router(AS 500) & ISP-1 (AS100). Since the two links are...

Hello all,We are having multiple links to our core site using bgp .one is shdsl and other is fiber.We have bgp and As no. provided by ISP .BGP is taken care by isp.on our remote site we have 2 interfaces configured with wan ips and as no.Both wan ips...

I have two routers connected by FR. One is physical interface and the other is sub-interface multipoint. But the VC is not coming up unless I use point-to-point. Please whats the reason.

Hi, Can anyone help me in how to decide the multicast scope. Putting it in simple way I have 4 Routers R1--R2--R3--R4. R1 is configured as RP and I need to configure scope in such a way that Multicasting doesnot forward after R4.Whether I have to co...

I hope that I will see some of you at Cisco Live in San Francisco. I will be at the conference taking some classes and spending some time in the Chesapeake NetCraftsmen booth. I hope that many of you will be able to be at the conference and that I wi...

I want block to Pc from communicating in the same vlan

Dear All Expert,I would like to ask you some question about,i would like control bandwidth on user.so some user allow 10kbps and some user allow 50kbps for access internet ( outside). Please help me to let me know how can i do on this?Best Regards,Re...

I have two routers connect through FR and F0/0. I change the bandwidth on the FR to 100000 to load balance between the two links. And also the hello to 2 sec and dead timer to 8 sec on both. But ever since then the adjacency on the two link keep goin...

I have just acquired and used 1811. I want to put the http traffic on FE1 and the other traffic on FE0.One of the LAN ports will go to the ASA that will do the rest of the firewall and routing.I need to setup policy based routing, but dont seem to fi...

Hi,I have a network 192.168.10.0/24....This is in my one of the branch n/w where some servers are kept.....In my DC i want to same segment as some of the servers from that branch need to be shifted with same IP segment..Dc ip segment is 192.168.11.0 ...

I still havent found the right PDF manuals for the 1811 so forgive some stupid questions...I got a 1811 from EBay, had to reset it back to scratch for my configuration. I thought I would configured on of the 8 LAN ports with a static that I then can ...