Routing

Hello,I have a strange question with regards to the config applied to the CSS. I have applied the config and all authentication works without fail and I can test access in the event of the TACACS server unavailable. The silly question is when you ena...

Does anyone know if you can use a Cisco 5505 with AT&T DSL? I was told that if I put the 2wire DSL modem into Bridge mode, that it should work using PPPoE on the Cisco 5505. AT&T is telling me that it won't work and that VPN is not supported

hi..I would like to adjust dampening rule in bgp at specific neighbor.. Is it possible?for example. Neighbor A and Neighbor established with BGP. but Neighbor A was so frequently routeing update to Neighbor B, So Neighbor B give to Neighbor A Panelty...

Does Cisco has any solution for ISP load balancing - other that to use BGP enabled internet router ?( We have seen some third-party devices like RAD is having some load balancer boxes that doesn't use BGP)

hi,i need to check if it is feasible to make one router telnet to another router when an event occurs (logging) and make a shutdown command on the other router.what did is:event manager environment _email_server 193.227.177.130event manager environme...

Current setup is 5 sites over MPLS using only static routes. I want to create 2 GRE tunnels because I need to pass multicast traffic from site to site over the carrier's MPLS network. 1.)Can I do this using static routes or do I need to convert from ...

Hi,I faced an issue in multilink between 7604 and 3825. Everytihing was working fine and all of a sudden i was not able to ping the other end of multilink. When I checked via console to 3825 end, it shows multilink IPCP was in REQSent state and LCP w...

Hi.If I have CEF enabled on a 7600 routers, its possible to load balance by paquet? how can I acomplish that balance?Tks

Hi,A prompt to erase flash comes when I enter command copy run tftp.please help because I entered on that prompt and then aborted that . now it show flash checksom error.Thanks,HS

Hey Guys,Can someone send me a link on how to configure port spanning on a cat 6513. I can't seem to find anything.Thanks,Brent

Guys can someone please explain in a very plain language why we use static route to null0 and can you please give an easy example as well.....do we only use this in BGp or it can be used in other routing protocol

We had a T1 from local bell company that has been worked for years. The local bell provides clocking for my Cisco T1 module. We had a Cisco 1700 with T1 module and here is the configuration on serial inferfaces:Our Existing configuration (working wit...

HelloI currently have a Cisco 871 router. When I configure the WAN interface with no ip route-cache the router adds no ip route-cache cef in automatically??Does anyone know why? Below is the output:With ip route-cache & ip route-cache cef============...